Search results for query: *

Voltage Limiter to Dash Ground. Confirmed continuity before attaching. Ended up taking off the plastic plug connector and spreading the existing female Packard terminal then adding shrink tubing over it. I'm calling this done.

I was running at Norwalk one year and had my teeth shaken loose at the top end. Found that the tube had been punctured and deflated but the tire held air. Maybe happened during the burnout and the tire sealed itself up. That was a frightening experience. I've never run tubes since...

How many would show you that you called them out lol Ford too. My room mate had them on his 65 Fasback Mustang and they seemed to work well plus I like the way they planted the rear end. Never drove a 1st gen Camaro that didn't suffer from wheel hop. The first time I dumped the clutch in one...

And no continuation at the 12V on the Voltage limiter which ads to the mystery.

Combined all 3 threads and moved to this forum. @dodgeboy440 @58belvedere @DeltaV @Budnicks @YY1 @RJRENTON @Big bill @PlymCrazy

Driveshaft vibration damper.

Back in the day, the guy who sold me my second GTX used the butyl under the stainless, and also blew the corners out with a hair dryer. Never had rot, and still had a perfect original trunk floor. Original corners were still rust free when this picture was taken in 2013, with 113,000 miles on...

Congratulations to both '44070dart' (FABO) and 'Pecos Bill' (FBBO) for correctly picking #19 Chase Briscoe to win the YellaWood 500 at Talladega SuperSpeedway. Each picked up -5 bonus points. Nobody correctly picked the race runner-up, #34 Todd Gilliland. '44070dart' (FABO) had the low net...

Since this topic continues, and as already noted a true and efficient wing requires adequate airflow especially on the low-pressure side. This being the lower wings surface on a car seeking downforce. Most of the benefit of a wing occurs on this side. Mounting close to other surfaces or in...

Interesting, thanks. Will they typically fill the entire length of the rear window at the bottom? or mainly the corners? Thanks, Mikey

:usflag::usflag::usflag::usflag::usflag::usflag::usflag::usflag: I received 1 of the only 10 available Ultra red chase cars!!! Auto World Store Exclusive! That's right! We've made 3% of this Auto World Store Exclusive release as Ultra red chase car and only 10 available as an Ultra Raw chase...

Can't see it through the filler hole?? Sounds like the tube needs a tweak.

some more swap area

Received an email last Friday...label created. Shipped on Saturday and delivered this afternoon.

I’m wondering if bench seats are different than buckets?

This is a "Shadow" Racing mopar/W2 block, is claimed to be from the decades ago Can Am racing series. A bunch of the engine stuff is being sold as a lot. I am trying to figure out the two blue AN fittings in the oil filter area. The large center one's purpose is obvious. The smaller not so much...

And lastly these pink and white wires these are at the end of the harness near the multi connector for the steering column. The white wire comes off that connector pink comes from somewhere else. I appreciate any help in this dont want to do this wrong and mess something help. Thank you

This is the purple cable and purple with stripe wire that starts at the connector behind the drivers side kick panel. I think I recall the two prong connector plugged into the two prongs on the steering column but I dont have any idea where the single prong went.