Search results for query: *

Soda jerk

Motion picture projectionist

Just take your time and make the templates perfect. If you cut it shy don't guess, even add some folded tape to the edge and trim again until perfect. Then your parts will fit perfect. If you're bead rolling trace your patterns with a sharpie and cut your parts at the outside edge of the...

Carpenter

I've been restoring my 68 Coronet and enjoy the challenge. Now I'm moving on to my trunk lid and would appreciate advice/insights from those who've gone before me. As you can see from the pictures, there's significant rust-through in the back corners, the latch area, and the back. I've already...

Tow-Truck Assistant

Worked at a muffler shop.

I am not asking for “where” he worked, I am asking for “what” he did as a job.

Worked at Montgomery Wards, like my dad did!

Hi Bob. XR4 would be correct.

Knife and scissor sharpening

I feel your pain brother. Just finished up PT for the rotator cuff tear when I fell as the result of my major medical event back in February. I have pretty good range of motion and I’m probably at 70%. Start PT in a few weeks to work on my gait. Still weak in the lower leg as from the strokes...

Pump gas

Sold the Grit paper.

Deliver papers before work

Glad you weren't injured any worse than you were... My brother recently had a similar incident with his dog... It didn't end well... Two broken fingers, orthopedic surgery...

About a week ago, I was walking my dog over to a big ol' hole he had dug, to discipline him a bit, hole was in the middle of the back yard just off my back deck, road base gravel, I don't know how he could dig in it & not wear his claws down to nubs I was gonna' shove his face in the whole &...

Insurance salesman

Bag boy

Must not be enough "old guys" left at OMC. That isn't unique to them. Too bad, but even bigger names like JD are losing their service and moving towards throw away stuff.