Search results for query: *

Hope your speakers fit. I have most modern speakers are too tall.

No aftermarket grilles that I am aware of. Originals are $150 and up.

Front upper headliner trim is painted with textured acrylic lacquer same as dash frame. Pieces above doors are same as exterior with gloss sheen.

Screws go through speaker cover, dash frame and into speaker.

Here is one in WV: FB link

I also have a 906 bare head here in Lansing Mi area. PM me if the other opportunity does not work out. Joe

Only used on Plymouth.

Both the linkage and fuel line sets are readily available on Ebay or aftermarket.

I have two NOS motors. Would have been C body motors originally. But, should work fine for 70-72 B body. $450/each. PM me for more info. Joe

These are the studs and nuts:

There should be 2 small studs near the defrost vents to mount the speaker. The speaker also requires an adapter plate from the factory. This is the adapter plate:

My 70 RR was built one day prior to this Bee at the LA Plant. Pretty cool Bee..... if I say so!!!!

I have a couple on hand. PM me the bolt length you need. Would prefer to sell as a pair. Joe

Yes, refer to other thread. You have the incorrect style nut.

Best bet is to find a complete hinge and replace it. They are plentiful. Check Ebay. Any 68-69 GB door hinge will work.

Whoops...hope I didn't offend you. Tons of these cars got aftermarket radios leading to dash mods. Good luck with your improvements.

Should be a matching gray wire on your dash harness. The tach has a separate harness with two wires that is required. One wire (blue) goes to the fuse box. The other wire (gray with black tracer) goes to bulkhead. There should be a hole in firewall about 3/4" dia. near the master cylinder. Then...

Several inaccurate replies above. The radio plates with 4 screw holes (as you show in your pice) are 1970 only. 1968 & 69 plates only have 3 mounting holes. All 3 years are different. There were quite a few 1970 unpainted bezels (delete and am style) floating around years ago. I assume they were...

Uncommon in general. I have never seen a 70 B body with this option in the wild. Only a couple pics over the years. I am not certain if they were only available with deluxe belt option or both style belts.

I am not certain one could get this completed in this manner. Removing all of the bezel screws (9 or 10) from behind and then the lens clips would be nearly impossible. Remove the entire cluster from front by removing the 5 screws holding it to dash frame. Also remove radio bezel to keep from...