Search results for query: *

That's it! And no I'm not Mopar Joe, I stumbled across his videos and this hits close to home.

Tried to post the link but it would do it, this is close to your build Kern and close to what I'm wanting as well.

I agree drivability is going to better with the pro flo but some of that is EFI. Dual plane or single plane - Carb vs tbi - the carb will have more max power every time, that's well documented. I'm would like to see if anyone has done A to B comparison: ie; ran a pro flo or single plane and...

Has/Does anyone have any dyno results of Edelbrock Pro Flow ET EFI manifold vs a single plane manifold? I see a few people have used them because of fitment or appearance but I have not seen any dyno comparisons. Runner length has to have some sort of impact, but how much?

On the TKO install the factory 833 reverse sensor fit into the TKO housing and used the facility harness.

I have not used a 727 on a 46 RH font. I have used a 46 RH in a 727. It does feel tighter and it is not as easy to slip in but it does engage fully.

Pm

It started washing off the surface rust in seconds and wiping it again just made the surface cleaner. It has a smell that reminds me of working on sewer pipes..... Combine that with the smell of molasses....yum. I missed a couple of spots as you can see.. After a few hours it left a tacky...

I poured the prep into a bucket and put the small parts in and started wiping down the parts with the pads soaked in the prep.

Concrete prep And pads.

Yes this is after washing off with the garden hose and that's it....I noticed that's it wasn't as grey as it was 2 weeks ago but still rust free.

Ok I finally bought some cement prep and pulled the parts out of the molasses.

Hmmm

Please take a picture of all four doors while you're there,

What shape are the rear door latches in?

Just in case

I guess I've never paid attention to the filler panels between the quarter panels and the bumper, or that little spoiler on the top of the trunk.

More It's been about 70 at night and '80s and '90s during the day for temperature. You can see the areas around the ball joints that I did not clean, the grease is not touched. Also notice that I was pulling a couple of parts out washing them off and getting another couple of parts and...

14 day check up I decided to follow all the parts out and wash them down the garden hose just to see the full progress.

Just molasses.