Search results for query: *

Thanks for the reply dave6t4 Actually was thinking 215 70 on front Thank for the reply!

Will these sizes work? 69 Coronet! Ready to get steel Magnum 500’s From Coddington. 15x7 4.25 BS. 15x8 4.5 BS. 225 70 15. 255 60 15 Is anyone running these sizes? are there any rubbing issues? Also thinking the BF Goodrich TA’s Appreciate the help in advance...

Appears only new 54 series Mag 500 steel are made in China! Has anyone made a recent purchase of these and could share your opinions? Thank you in advance dcmason69

Anyone have or had experience with the Legendary aluminum wheels? Looking to maybe get 15x7 and 15x8 rims. How about the finish on these are they polished with clear coat? Also if you went with the bullseye caps they say they are press on! Can anyone elaborate on this. Thanks in advance...

Appreciate the help to all! My situation is I have 2 outer pieces originally 69 and the Center section from a 70 which some one painted gloss black used paint remover to remove old paint ! Know originally it was a brownish as Dadsbee said I am not going concourse! Most what I see at shows have...

What is a good shade of black and brand for ramcharger duct work? Satin, flat, or semi flat Used Eastwood under hood black satin for brackets etc. But thinking a little too glossy. Any help appreciated! Thank you in advance

OK Thank you gKent your information is just what I needed ! Bought used seats and no 2 things are the same! This clears up things. Appreciate your help dcmason69

I see gkent good iinfo: So the 1/8” washers went over the shoulders on the bolts I assume and so were these virgin seats ? If so were the washers on the inboard or outboard of seats? Just curious! Thanks for your help

Thanks Mopar Hunter but I am working on the seat hinge bolts! Not seat belt!

Hey that is good to hear! Can you tell me is there any other washers etc. used besides the fiber washer between hinge and seat ? Thank you

What is correct bolt setup for 69 Coronet bucket seat hinge ? Top pic has 5/8 shoulder and bottom is 1/2 the 5/8 are marked with a N and no markings on 1/2 “ Also any other washers besides the repo fiber ones from classic ind. Between hinge and seat? Thank in advance dcmason69

Sail panels in 69 Coronet Does the bottom edge tuck in along edge of package tray or sit on top ! Tray will have sound deadner under it ! So it will sit up 1/4 to 5/16 off shelf How did these come from factory? Thanks in advance dcmason69

Ok I see how that would work. Learned something new! Thank you Bob Not my first choice but the cost for me to buy a used core and then pay for a rebuild, made me opt. For a china rebuild. Hope it doesn’t bite me in the butt!

Yes i agree for the bendix fork etc. But I can feel the armature hit back and forth against the end plate feels like more than 1/8 inch. Thanks for your input Just my thoughts that armature should not have to much end play? dcmason69

Purchased rebuilt large frame starter from Oreillys Notice if I flip it end to end it feels like the armature is sliding back and forth! In my mind there shouldn’t be that noticeable. Did not see any info in FSM on this Iam Leary to put in. This is the 1.8 3 and 3/4 housing can anyone...

No no yokes on shaft !

Thank you RemCharger that is what I needed to know! Straight and to the point! Thanks. dcmason69

One end of my drive shaft is tapered down about 5 inches from one end. Which end goes towards front of car? Not a virgin just want to be sure before I install! 69 Coronet 727 8-3/4 Thanks in advance dcmason69

So is it same for 69 ?