Search results for query: *

Thinking outside the box Chad Weber took the no ladder format to his advantage in Super Comp. He and his dad hurried up to be first in line in staging so they could run each other. His dad left before the tree activated on purpose giving Chad a free time shot in rd 1. He ended up winning the...

The Cowboys.

18k RPM! ... remarkable (@ appx 1:38)

During my dealership days I was the suspension guy. Worked very closely with our body shop doing the parts replacement on a lot of wrecks. Though I didn't do the pulling I was involved in more than one that didn't get pulled far enough. Always pull it as close as you can get it before removal...

I'd like to see a larger picture od th eentire set-up. As I remember this shifter a rear exit cable design and uses a bell crank to swap cable direction. Is this what you have? I believe we extended the line outside the bracket. Doug

But isn't this forum supposed to be about what guys are having problems with and they get discussed to hopefully find a solution? You think it rocket science to put a starter in? Sure, I'm having a problem putting in a starter that really wasn't made for a 67 Charger, but that's why I asked. Any...

I measured the nose part that you have circled in red. It measured the same size as the OE starter and the hole where it goes is round. Something is stopping me from installing it all the way and I can't see it. Problem is, I don't want to hack up one of these starters only to not have it fit...

Pull harder. Unless some fool glued it on, but they're just a friction fit.

Well, what are they asking for it?

1960: 2025: And no notch.

Thanks, but knowing that, I’m going to pass.

I have a few here all I do is Mopar distributors if needed.

Silverado

Doing some testing on using a relay to activate/cleanup the engine ignition wiring, and found the relay needed around 7.75 Volts or better to activate which shouldn't be an issue when cranking if the battery cables and wiring is half-way decent? I just got an ACES EFI kit that came with a...

Bump

Bump

It is not hard, it is being done everyday; it is a very simple device: a wire wound resistor with a wiper arm. You cannot get that wrong if installed correctly. This assumes the resistance is correct.

The Good, the Bad and the Ugly.

SOLD