Search results for query: *

I don't have experience with a 65, but i'm guessing that your issue may be at the rear terminals of the alterantor ( amp meter) gauge. A short to ground on either wire connected to this gauge will burn up the link. In my 66 Charger, the 2 studs that come from the rear of the alt gauge housing...

Where is the shoulder strap anchor on the roof for a 68 GTX located ?

Nice pictures!! Saved me some time!! LOL :thumbsup:

And to add further, if the transmission functions just fine and doesn't make any noise I wouldn't do anything further other than stopping the leak. No sense in rebuilding something that doesn't need rebuilt lol.

Bandidas with Penelope Cruz and Selma Hayek. Yum and Yum! May not be the best, but a fun watch.

....and don't forget to either drain the gear oil or plug the hole where the driveshaft yoke goes in. Depending on how much you tilt it you could end up with a large gear oil leak :lol:

I used to go to a lot of car shows. Now I just go to some Mopar specific ones my club sponsors, and Moparty. Other than that, just one all make show an over 55 community sponsors and donates all the proceeds to a local charity. As I get older, being out in the sun on a hot day has gone from...

Welcome! Were these shown in Boston at the World of Wheels there, I may have seen them? If you are on Facebook you might want to join my group as there are a lot of local Mopar people from years ago on there, some may have known him.

Thanks a lot that really helps alot

Never have cared about winning a trophy at a show. If you don't go to a car show caring about trophies, it is a much more fun experience.

Most likely the input shaft seal, behind the front bearing retainer.

started building a laboratory about 45 minutes north of here at a place called Uncle Skunk's, they make THC distillates they combine with different flavorings. The new Prozac. :lol: :fool::fool::fool:

:thumbsup: Or sitting at car shows every weekend day. The drive there and back are way more fun than sitting in a fold up chair looking at it. Once I`ve seen all the cars and talked to the people it`s usually time for me to leave and burn some gas and rubber.

Looking for a decent set of 915 B/RB castings, no damage, no modifications, no over-size valves. Looking for castings only without any other parts. PM me here if you have something of interest. Thanks for viewing, much appreciate.

aiming guns

I wanted to do one for my 74 and did a lot of research. Unfortunately for me, but good for you they stop at 72 for B bodies. This is what I would have gone with if they made it for my car. https://qa1.net/...

Looking for a front driver side fender for a 69 coronet. Im near Raleigh, NC

nice detail shots