Search results for query: *

Blew the last of the leaves into the woods and cut the grass for the last time & started to clean and winterize the JD mower. I’ll finish that up tomorrow & put it away in the basement.

I have found the weigh scales quite useful for determining the weight of the Tukvan. About 6800 depending on load, but it is usually about that.

God I love this machine..

If you have to open the primary blades too far to achieve a stable idle with that large 850 carb, you are already "into" the transition circuit at idle, which causes a lean condition at light cruise.

Perfect. Thanks much!

Old school is not DEAD..... offering to god of speed

I'm 74 and feel like I've been run through a meat grinder! For me, trying to get up from a creeper is a job let alone get up out of a car after laying flat on my bad doing under dash work lol Was wondering what made the car look like it was out looking for something to devour....then I saw...

Happy Thanksgiving to all !!

if that means what I think it does, I'll just stick with the hummer :thankyou:

dont know , im running the holleys, 4235/36..

I wound up rebuilding my starter and gave up on the mine starter, But I measured what your talking about and they were both the same. It sort of felt like that was the problem, but I couldn't see the problems laying on my back trying to put the damn thing in.

I bought one of these on Temu....pretty close to my rates :lol:

Age really is not the issue, health is. I wish I could, but I'm still walking with a cane from an accident in June of '24. I can't be on my feet for more than 10 minutes, and then I need to sit because of lower back pain. BELIEVE me, if I could I would, but reality is what it is. I know how to...

It's a plastic or similar coating that is peeling off - even if I paint it won't be right. However, Sharon's Web got back to me and estimated $1350 to restore them - ouch!! I guess I'll clean them up and see what I'm really dealing with first.

There is a "swoop" because it transitions from the front fender bulge to the rear quarter panel bulge. Unfortunaly I have no photos that really highlight it

The comp cam ran out of steam fairly early. I think the short intake duration, 110lsa, and 4 degrees of advance wasn't ideal for my engine. It blew over 190psi, closed the intake valve at 60 degrees ABDC; i think too early. Put it in straight up would help or use in a low compression engine. I...

Thanks Guys, I just needed to tweak the new ones a bit, and they are now installed. Any market for the old original ones with obvious pitting? Mike

Gator and Gone in Sixty Seconds