Search results for query: *

Take off any interior part that is still installed. Now wash them up good on both sides. Now flip them over and the color underneath that is not sun faded will show you what to get.

Just line up the oil hole,, that's the important part. The notches are on current bushings, not originals.

Rear end gears are the first thing to change. 2.7 gears are killing the torque. Remember jumping on a 0 speed and it still in 10th gear? Hard to get the thing moving. 3.2 is great for all around driving. Don't go to much with a small engine, like 3.5 and up.

You can turn it inside the car on the column. The most forward part of the column housing moves as it's connected.

When you bolt it to the floor and hold the brackets in place then will it behave properly?

After the oil change it is really easy to remove the relief valve and spring, inspect for wear, install a washer and see the increase in pressure. Cost? $0 and 30 minutes.

It is easy troubleshoot the brake light switch. It is an on off switch activated when the pedal is pressed. Pink wire has power from fuse box, white wire sends power to TS switch when you step on brake pedal. Switch is hard to get to with a clutch pedal car so test for power on white wire at...

Why not straight 50 weight if we are trying to raise pressure with the fluid.

Which side is the one with a hole in it?

Industry number DW 671 for a 2 door hardtop. Sedan and convert are taller, same width at bottom edge. Same lower trim and cowl. What body style do you have?

What oil filter? Start at the oil pump relief valve and spring. Maybe it's an old worn out pump. Maybe the bearing clearances are loose. Put a flat washer in the cap of the relief valve to increase pressure is a quick fix/bandaid. Does it run good, hitting on all 8 cylinders? If a pushrod...

That intake is a poor design. Get a different stock one from 1970 or newer and the carb will fit without any adapter. Or get an aftermarket aluminum.

A stock console won't fit over that, the lever is too far to the left. Get a boot.

Did you install throttle pressure linkage? Also know as kickdown linkage?

Brewers says use this sta-lube SL-24239. Brewers is a vendor that specializes in mopar 4 speeds.

This yellow bottle is ATF based and not to be used in an old 4 speed.

Is there any chance you could gently wash these so we can see the actual condition of them?

Find it. Engine in car or on a stand?

They made one knob and it is labeled on both sides, TOP and R WIND.

1958 thru 1966 is shown in the photo. 1967 up it goes on the other side and screws in from the front. The change was for the 1967 model year. They also changed th bolt body for the alternator bracket. So the bracket changed for the non A/C cars. That's when the triangle bracket got the...