Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I had the same issue on my 76 Volare Road runner.
When I bought it - it had an 8 3/4 from a 66 Charger.
All I did was have a bushing machined to fit inside the isolator hole and a small hole in the center of the bushing to locate the leaf spring pin.
You are correct and the flap should cover the rear of the block. But the short part of the flap where attached to the liner is in the same position as the mounting strap for the fuse block. How does that piece go around the mounting strap? Do I cut a hole/slot in it for the strap to slide through?
Probably new ones aren't needed. Take them apart for inspection. Clean them if needed, inspect, and replace as needed. May be they only need repacked, may be just adjusted. I'm sure there's some endplay spec in the service manual. In 50+ years I have never measured and have never had an issue...
Good reading guys and good timing on this subject. I have all my wiring and dash on the bench right now. I have removed the ammeter shunt and replaced the gauge with a voltmeter. I am installing relays for the headlights, power for the headlights is the "relay feed" on the starter relay stud...
Hi Guy's,
up for sale are a pair of bumper guards out of a 1962 Dodge Dart 440. Mint condition, on each side there has been one stud cutted. Can normally be fixed easily.
Asking 80$ for the pair plus 30$ shipping.
If you have any questions pm me.
Marcel
I have screwed an air fitting into the spark plug hole on compression stroke and plugged in an air hose to find a burnt valve.......it obviously blew air out the tail pipe
I took my Road Runner in for new front tires before getting the front end realigned. The tires were shot because I seem to have too much camber diled in. While at the shop the tech pointed out some endplay in the front wheel bearings and suggested I look at if I needed new bearings before the...
Hi Guy's,
up for sale are a pair of fender nameplates of a 440 Dart 1962. Overall good condition, chrome ok, no pitting. On one of the nameplates are 2 studs broken but can be fixed easily.
Asking 80$ for the pair plus 20$ shipping.
if you have any questions please pm me.
Marcel
This is a OEM Big Block 727 transmission Inspection Cover W/bolts.
It is original, not a china knockoff. It needs a cleanup, and it
does have a small crack in it as you can see in the pics. $20.00.
Local pickup, or buyer pays shipping.