Separate names with a comma.
Welcome form Aurora, CO
Welcome from Aurora, CO
The Dynomax superturbo mufflers are fairly quiet and flow pretty good. Also not that expensive. A stock replacement type muffler will be fairly...
Use the Hughes HUG-8319 Lifter burnush ball to make sure the lifter bores are nice and round. Make sure lifter bores are clean and no edges or...
Attach battery power to wires, motor should turn one direction. Reverse power polarity and motor should turn other direction.
That 440 source windage tray is pretty deep. I think it will fit inside the milodon oil pan? it is too deep for a stock or street hemi oil pan....
I don't think you will save money putting the 4.75" crank in a stock 440 block. If you want a 572 engine start with the large bore aftermarket...
I wore a T-shirt and shorts snowplowing the street in front of the driveway today. My daughters car kept getting stuck in the snow.
Had the snow blower out yesterday (Poulan Pro 24"), and there is a honest 24" of snow in open areas, with 3-4 foot snow drifts. Snow is pretty...
Had some Anchor engine mounts that were junk too.
Been thinking of making a body jig/cart for the '69 Convertible before attempting to replace the floors, trunk, and rear quarters.
The 3.54/3.55 ratio works good in most case. The actual tire height will matter too. With the big engine and short tires the 3.23 gear will be...
And I need Bread and milk too, but have almost a full case of beer. These March to May type of storms are good for taking out trees and...
You can use "flux" core wire in a MIG welder if you don't have a shielding gas, but the results in more weld splatter. It also seems to burn...
Best results from having the metal clean. With baffles in a valve cover and real thin metal I like pulsed TIG, but MIG can work, just need to...
Sounds like you have some equipment. What are you trying to weld? What steps are you taking to learn to weld? Most machines will weld carbon...
My friend and I assembled the Bendpack HD9W in a day. The runways were the most difficult to move around. We put them on harbor freight wheel...
power is more limited to head/air flow and how hard you want to spin the engine. Less CID, just need to spin it more than a larger CID engine....
Looked at the pushrods again and the bent one looks like it would be longer than the others if it was straight? It also looks like the cup is...
Check that the pushrods are not hitting the cylinder head pushrod holes. There appears to be wear marks in the center of the pushrods? That might...
