Search results for query: *

Which is the correct sending unit for a 1968 Dodge Charger 318 Automatic, A or B? Thanks

Need a set of valve covers for a 1968 Dodge Charger with a 318 engine. Must be complete in excellent condition with the metal tags used to support the ignition wires. Thanks!

318 Engine with Air Conditioning: Here are photos of the front and back of a fan. Is this the correct one for this car? If not, where can I purchase one like the original? Thanks!

Questions: 318 Engine: Several items are broke off on my valve covers. Where can I purchase ones like the originals? In back of the water pump there is a flat metal area before the thermostat housing. Mine has a lot of pits. What is this housing called? Could the pits develop into a...

What color should the valance and the front bumper bracket center bar be painted? Thanks!

Is it necessary to prime and paint the underside of brand new bumpers? If so, what paint is recommended? Thanks!

1968 Dodge Charger: I need to know placement and how to install the wire covers on my new floor. I have a long one and a short one for each side. The old wire covers were already rusted away when I got the car. If the covers are closed on both sides, how do you install the wiring? Any help...

The photos (rusty piece with the light shining on it) are the brace at the bottom between the grill and the radiator off of a 1969 Dodge Charger. Is this part also needed on a 1968 Dodge Charger? If so, what is the part called? Thanks!

The parts in photos are off of the bottom rear of a 1968 Dodge Charger. Did the 1967 Dodge Charger also have this part? Thanks!

1968 Dodge Charger: I need measurements for the exact location for the spare tire hold down bracket and the two trunk floor spare tire supports brackets (one left, one right). See photo. My original floor was totally rusted through and the brackets were gone. Measurements and a photo would...

1968 Dodge Charger: I need the bottom chrome exterior trim piece for the driver's side rear window. Thanks!

Should the nuts at the end of the torsion bars and the stabilizer bar end links be painted? Thanks!

Did the 1968 Dodge Charger come with trunk fiberboard panels on the sides and back? If not, is it just left open so you see the inside of the rear quarters, top of the fenders and the back of the lights? If all of this shows, what color should the inside quarters and fenders be painted? Thanks!

Were the camber bolt adjusters painted the same color as the car and shock towers at the factory or were they left unpainted? Thanks!

What vendors sell the mounting bolts for all of the seat belts for a 1967 Dodge Charger? Thanks!

I am looking for the stainless steel molding that is installed under the grill on a 1967 Dodge Charger that is in excellent condition. Thanks!

Does any vendor make the stainless steel bottom grill molding for a 1967 Dodge Charger? If not, are there any vendors that can remove scratches and dents and replate the molding? Mine doesn't look very good. Thanks!

Regarding the front shocks, were they painted on top including the rubber grommet that goes through the shock tower, the same color as the car at the factory? My car has a black interior. What sheen of black paint should the metal part of the dash be? Thanks!

What sheen of black paint is the area across the back where the tail lights are installed? Gloss, flat, semi-gloss, satin? My goal is to use the same black sheen as the factory did. Thanks!

1968 Dodge Charger, 318, 8.75 rear end, 904 transmission. What is the proper method for measuring the length of the drive shaft? What length do I need? As long as the universal joints fits, do I need to be concerned about the length of the yoke? Thanks!