Search results for query: *

Don´t know what you call these? The plates are sitting behind the headlight buckets. I think they are from a Coronet -66 but should also fit -67. They are solid but note that they are repaired in the outer edge. Asking $35 for the pair + shipping from Sweden (shipping to US would be $25). Thanks!

I´m missing the correct hook and tire iron for my bumper jack assembly. The hook should be stamped with the number 2461 129. The type I have is this one (picture borrowed from nicksgarage.com) Thank you!

Is this the right type for a Coronet -66, HT? Thanks!

Hi, Looking for the sill plate support for passenger side (right side) for a Coronet 2dr HT -66. Also interested in the original screws, mostly to see what type they are. Driver side (left side) in the picture. Thanks /Mattias

Looking for a tinted vent window right side for a Coronet -66. Need only the glass. Thanks

Hi, Looking for this bracket that sits (or should sit) on the vent window frame at my Coronet -66. Thanks!

Looking for new inner door handles for my Coronet -66 HT. OER have a reproduction set with part number MD2145. BUT these are listed as only -68 and up at most retailers. have also seen some retailers that listed the same part number for -66 and up. Does the OER fit -66? What have you used...

Hi, Looking for the bracket that holds the masonite over the spare tire. Also looking for the stamped 3/8” wing nut that goes into the bracket. Thanks /Mattias

Looking for the lower rod for the shift linkage. Coronet -66 with 727 trans - console shift. Thanks!

Hi, I need to replace a big part of the trans tunnel on my Coronet -66 since earlier owner have had it massacred. Anybody have a nice rust free tunnel? Picture is borrowed, the tunnel is not from my car but this is what I´m looking for (without the rust). Thanks!

Ok, I know this is a strange question... I would like to by a moped (restoration object) on eBay. The problem is that I live in Sweden and the vehicle has no title. The seller aranges shipping within 60miles radius from Madison WI. Would anybody like to receive the moped, dismantle it and...

Extreme long shot.... Miss the fender tag WP23E61110759 for my Coronet -66. Thanks!

Hi, I need to replace a big part of the trans tunnel on my Coronet -66 since earlier owner have had it massacred. Anybody have a nice rust free tunnel? Picture is borrowed, the tunnel is not from my car but that is what I´m loking for (without the rust). Thanks!

These lugs were installed under my Coronet -66. Are they original or are they som previous owner’s own invention...? Thanks!

Right one is really good, I would say 9,5 of 10. Left one has some light scratches and some small imperfections, I would say 8,5 of 10. I´m asking $125 each + $70 shipping (Sweden to US) /Mattias

Splash shield left side, rear of wheel. It is blasted and painted with 2c epoxy primer and black 2c top coat. During blasting some small rust holes showed up. In total about ten holes, some of them can barely be seen. $50 + $50 shipping (to US from Sweden). /Mattias

Need the ”S-clip” between the two torsion bars for the trunk lid. Thanks

The clips on the trunk lid torsion bars, what are they for?? Thanks

Splash shield left side, rear of wheel. It is blasted and painted with 2k epoxy primer and black 2k top coat. During blasting some small rust holes showed up. In total about ten holes, some of them can barely be seen. $65 + $50 shipping (to US from Sweden). /Mattias

Hi, Anybody have a nice pair of trunk hinge arms for a -66 Coronet? Thanks! Mattias