Search results for query: *

When reinstalling the alternator on our ‘66 Coronet I “ assumed “ the black wire was a ground . There were three wires . A dark blue that I plugged into the “ field “ spade connector. The thick red ten gauge went from the threaded post directly to the battery . In hindsight I should have...

Two weeks ago I finished welding new floorboards in the Coronet . I thought I was finished after undercoating , installing a layer of sound proofing and new carpet . When I started up the car to drive it down off the ramps , the throttle cable snapped . I made a throttle cable from an old...

The aluminum timing chain cover leaked coolant from corrosion after only 58 years . The gasket kit came with a felt seal . Does this get used on a ‘66 Polyhead 318 ? There want one when I removed the cover . Thank you What types of sealant are we using ? Thank you

Due to the serious leaking of coolant from what I believe was between the block and the timing cover,I removed The water pump and timing cover . The coolant passages from the block appear to have been eaten away . I’m familiar with dissimilar metals corroding . The motor in question is a 318...

While putting new carpeting in , I noticed the rear courtesy lights were on even with both doors closed . I use the term courtesy lights as they are in the back seat . Our ‘66 Coronet is a convertible . The drivers door switch flickers and the light get dimmer when you push it on . Even when...

I finally finished the replacement floor pans . Only problem was when I fired it up to take the car off the ramps coolant ran “ quite freely “ from where it appears to be behind the timing chain ? As far as I can see , it is not coming from the water pump or the intake manifold . I wiped both...

While underneath our ‘66 Coronet which has a 727 transmission, I noticed the rear support bushing is mushy and broken . Who do I order one from ? Can I just raise the tail of the tranny just a small amount to pull and replace ? Thanks

I'm in the begining phase of adding an aftermarket under dash stereo . Preferably I would like to tap into the fuse block . I'd really like a clean factory look . Is there add on fuse assembly one could purchase ? I'm not of opinion that it is ok to cut into the factory wiring . I looked here...

I'm not quite sure how many of you fine folks actually laid out a plan when you arranged your garage . As for my self ,I've just sort of made room for new tools and bigger pieces of equipment . I'm about to haul ablsolutely everything out of the garage and barn and start over . If you were to...

I've notice the coolant gradually disappears from the radiator after drivng for several hours . When parked there is never any signs of leakage on the floor . At this point, I'm thinking the seal on the water pump is leaking once the engine warms up . It the water pump from a 318 polyhead...

Most tv shows are fairly boring , to me anyway . I took a chance on the series ,Dark Winds . Unusual story line , unusual cast of characters . Thoroughly enjoyable . How ever , the part I like best are the cars in the background . The storyline takes place in the early 70's onan indian...

https://bringatrailer.com/listing/1970-fargo-power-wagon/ I'm fairly familiar with GM's Canadian brands and models. I've never heard of the Fargo before . Heck ,as clean as it is ,I'd buy it just to see the DMV's expression when I apply for plates and a title

https://bringatrailer.com/listing/2011-dodge-challenger-drag-pak-4/

After way too long of a winter ,I decided to pull the '66 Coronet out of it's winter storage. I was surprised and horrified to find mice had chewed a hole in the convertible top fabric. To say the Mrs. wasn't please was an understatement. How does one go about finding a reputable shop to get...

I'm about to flush the coolant out of the '66 Polyhead . A very long time ago , late '70's was the last time I remember doing something like this . I cut the heater hose coming from the thermostat ,going into the firewall . Is this still where we cut to install the "T" ?

I’m thinking he will get the full $25,000.

We happened across this yesterday at a car show in Watertown Wisconsin. Factories offered some pretty interesting options in the ‘70’s

Barn-Found 1933 Dodge Coupe Looks Incredible After First Wash in 58 Years I'm thinking there were several sons and fathers who thought eventually they would get the keys..

Houston woman faces jail for screaming in Dubai