Search results for query: *

Hello all Will a 1967 plymouth gtx Satellite Belvedere k frame work on a 1969 roadrunner? thanks all sjm

hello all Picked up a 69 RR replaced the gas tank and used the rubber seal that came with unit cant seem to keep gas from sloshing out the rear of tank . Replaced the gas cap any suggestions on a bad *** seal and possible bad *** gas cap. at this point i dont care about cost just want the fuel...

1973 challenger exhaust hangers i am running a duel exhaust on my 73 340 challenger all i see is only left side exhaust hanger is it known to put a left bracket on the right side? will need to drill holes to mount the right side if i use a left bracket am i missing something on a duel exhaust...

hello all 1973 challenger 340 automatic i dont know where the nox valve hoses go to can anybody help bottom of valve states carb but where at the carb and the top of valve nipple i have know clue. any pic would be great thanks sjm

hello all Sent my dash out to get recovered best time to go through my heater box my question is up at the front windshield is there a foam gasket that is adhered to the vent thanks all

hello all Is there a difference with radiators from a big block 383 b body RR and a 426 hemi inlet and outlet hose orientation. Presently my 383 both in and out are towards the driver's side of rad. Also want to go from 22inch to 26 inch with clutch fan. any help would be appreciated. thanks sjm

hello all restoring a 73 challenger had trans rebuilt but need a torque converter for a stock 340 with stock gear train any suggestions on a budget converter that will do on the street any stall suggestions thanks all

My roadrunner 1969 has the front fender support rod braces my 73 challenger does not were there any on the e body challengers there are factory holes on the bottom of fenders but dont know if they are for thanks all

hello all is the beep beep horn a roadrunner triggered with two horn steering wheel hits or is there something that automatically beeps twice when you hit the steering wheel once? thanks

can anybody tell me what these are? thanks

i need help tore car apart many years ago and dont know where these go and what they are thanks all / where do they mount to 1973 challenger couple pics below sjm

hello again Is big block torsion bars the same size with 383 or hemi? if not any recommendations for a 69 RR hemi torsion bars? Mine are possibly stock from factory size please from a 383 to a hemi / aftermarket suggestions thanks all sjm

hello all Want to install a mega hemi Siamese block into a 69 RR wondering if while car is down installing a 26-inch radiator opening currently i have a 22 inch is it nessesary street machine clutch fan with 160 thermostat automatic thank all for your advice

hello all I would like to install a gen 2 hemi with Schumacher conversion mounts to a big block b body k frame. Motor has an external Milodon external oiling system with feed out from pump towards the motor mount. I was warned there will be problems getting hose and nipples to clear the motor...

p4532267 intake anything special about this intake? thanks

hello gang p4532267 hemi cross ram anything special about this intake? want to put two holly carbs on any suggestions on a throttle linkage set up from a vendor for two Holly's thanks sjm

hello all are there any lock washers or washers under allen bolt fasteners for cross ram intake thanks' sjm

hello all what is the diff between hemi engine wiring harness verses a standard 383/440 motor thanks sjm

hello all are cross ram fasteners all the same length? thanks

hello gang have 383 automatic RR just put a carb on motor with electric choke ant suggestions on where to get proper source of 12 volts thanks