Search results for query: *

This is the clip I have been looking for. I have one good one and need a full set to install the trim piece on the drivers and passenger side. Please see the attached images. If you have any or know of a source to get some I would greatly appreciate it

Could you assist with some trim clips I have been looking for quite some time?

I am in the process of attempting to convert a 62 to power brakes. I purchased a kit from Mancini that states it will fit a 62. After receiving the MBM MP 710 kit I ordered the first thing I found wrong, other than the vague pretty much useless directions, was that the pre-bent brake lines going...

Is a 1962 3 seperate pieaces or is it supposed to be spot welded together as shown?

there is a supplier even though people will tell you there is not, I got a new rear last year from them. I will dig through paper work and post the supplier and part number. It took me months to find mine.

still for sale?

Ugggggggg,,,,,thank you! I only referenced the ignition boxs and distributors!!!!! i didnt think to look up the pick up.....i feel dumb. THANKS AGAIN

I noticed while installing this today. I have a new Msd box going to an older msd distributor and of course the tech support is closed on a saturday. Im not sure how to wire the weather pack connector im making. I know the 6al box wires to the distributor are, Green/+ and Violet/-, but on the...

thank goodness its not 2 1/2

There was a lot of geometry theory explained to me, but to my posted questions, steel shims are not necessary between the rockers and spacers, but they would have at least .025 of clearance not .005-.010. The spacers aren't spinning at any sport of "rpm" to cause galling. On a side note the...

I called and spoke with Dove manufacturing today and they cleared up a ton of my questions and concerns

I am speaking about side to side clearance, and also just running aluminum spacer to the aluminum body of the rocker. Hughes is the one who advised .005 - .010 was ok, but that seems tight to me. I worry that the aluminum on aluminum will gal. I have no real world experience to know how much to...

When centering these rockers over valve tip I was advised it is not necessary to use the .015 or .030 steel shims, if alignment was good. That would mean the aluminum body of the rocker would ride on the aluminum spacer required to get the correct offset. Will that be acceptable when you have...

Following.....just found 2 bad crane gold rockers on my motor. I'm now shopping for a new set myself, I wish I could get more feed back on the Hughes product as their price point is better for my budget

It's just a street motor we are playing with

starting out with out of the box QUICK FUEL 750's ...22-74 jets

factory style

Is there a "rule of thumb" to go by as to what SHOULD be, in THERORY, the leanest cylinder on a 440 mopar? The combination in question is a 540" with crossram intake. I will be putting it on an engine run stand next week and have an extra EGT probe and gauge sitting around, so I was going to...

When installing any system such as this you need to plug the original hole inside the block where the stock pickup was located. Is there any reason I CANT use a brass plug that I was able to find with the correct thread or would it have to be a steel plug? I'm probably over thinking this but Ive...

The block is a stroked 440, and I'm running a Milodon 7 quart, plus filter, "30930" pan with a 1/4" thick main bearing girdle. I'm trying to figure out how to determine where the perfect oil level is and mark it on the dip stick. The motor is 100% apart and on the stand. I'm sure there a correct...