Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Did you resolve your issue? What was the problem? I just installed my digi-tail kit in my 66 and so far its ok but less than 5 minutes of run time so far..
UPDATE.
First thank you to everyone that offered advice.
Second I feel like a dumb @#% for forgetting to mention I have a line lock on the car. The line lock was the problem it was holding pressure on the brakes even though the switch was not activated and only when the car got hot. So I...
My brakes have started locking when the car get warmed up and engine bay is hot. I replaced the master cylinder and added a heat shield thinking that was the problem. But after a short test drive today to the store they still are locking after engine bay gets hot and I park the brakes will...
I think its an A&A valve body. And its a reverse manual not sure if that makes a difference. Im concerned because I think reverse and 1st run on a different drum?
I replaced my transmission with a freshly built 727 with rvmvb and 3500 stall converter last year. It creeps backwards in neutral. I thought it might go away after it got broke in a little but 300 plus miles later it still creeps. Should I be concerned? Its not a powerful creep .
Update: I was able to road test today. Warmed car up to the point the gauge had dropped to near zero and took out on 55 mph road. Ran it through the gears a few times up to 5500 rpm and no starvation issues with the 600 cfm carter.
So i have concluded that the gauge reading is off due to heat...
My fuel pressure is 9 cold then falls to near zero when it gets hot. Tank is new, new 3/8 fuel line, new carter m6903 pump and 3/8 line with filter to carb. The line from the pump to carb is routed up between alternator and water pump and on to top of intake manifold. I only run non ethanol...
Can anyone that has ran an Edelbrock performer RPM# 7193 tell me if they needed a different throttle cable bracket and or cable? I have a 66 Charger with a 440 it will be going on. And by the way Summit finally has some in stock. Amazon has them as well but i think they get them from Summit...
Thanks for sharing your experience with the led's.
You recommended solder sleeves but from what i read in the instructions it suggests joining all the wires (6 or 7) together. Did you do yours differently? I can solder and do all the electrical work I just dont know alot about how to layout a...
Thanks for the heads up on cleaning the inner housings good. I ordered the set from Digi-tails. Where did you tap into 12 volt constant power? I was thinking about using the trunk light for 12 volt constant power.