Search results for query: *

New trunk and floor pans have been installed so no hoses are present.

Excellent explanation, but unfortunately most of my parts were stolen so I don't have anything to look at. I need to purchase a new tank. I think the sender marked A (top photo) is the correct one. The filler tube has a place for a small vent line. I assume that goes to the tank. Most tanks...

Is this the metal tabs, in the photo from MEGA Parts, that are welded on top of the valve covers? Does a plastic holder for the wire fit on top of the metal tabs?

How do I determine which one I need? The filler tube has a small tube at the top for a small hose. Is this the return line, or does a return line go back to the engine? I also need to purchase the correct fuel tank. The car was purchased new in Illinois, so I assume I need a tank without...

Which is the correct sending unit for a 1968 Dodge Charger 318 Automatic, A or B? Thanks

Need a set of valve covers for a 1968 Dodge Charger with a 318 engine. Must be complete in excellent condition with the metal tags used to support the ignition wires. Thanks!

Would placing an ad here under WTB be the best place to start?

Difficult to see in the photos, but the metal tabs that the plastic separators hook on to is rusted away and broke off completely in two areas.

318 Engine with Air Conditioning: Here are photos of the front and back of a fan. Is this the correct one for this car? If not, where can I purchase one like the original? Thanks!

Questions: 318 Engine: Several items are broke off on my valve covers. Where can I purchase ones like the originals? In back of the water pump there is a flat metal area before the thermostat housing. Mine has a lot of pits. What is this housing called? Could the pits develop into a...

What color should the valance and the front bumper bracket center bar be painted? Thanks!

Is it necessary to prime and paint the underside of brand new bumpers? If so, what paint is recommended? Thanks!

Three questions: Which way do the tabs face, toward the inside of the car or to the door? Are the tabs welded and act like a hinge? Long one first and then the short one? Thanks!

1968 Dodge Charger: I need to know placement and how to install the wire covers on my new floor. I have a long one and a short one for each side. The old wire covers were already rusted away when I got the car. If the covers are closed on both sides, how do you install the wiring? Any help...

The photos (rusty piece with the light shining on it) are the brace at the bottom between the grill and the radiator off of a 1969 Dodge Charger. Is this part also needed on a 1968 Dodge Charger? If so, what is the part called? Thanks!

The parts in photos are off of the bottom rear of a 1968 Dodge Charger. Did the 1967 Dodge Charger also have this part? Thanks!

I found one and will check it out. I will let you know if I need one. I am sure I will need other parts, as several of my parts were stolen. Thanks!

I deleted all of my messages. Please try again. Thanks!