Search results for query: *

Looking for a nice condition trim ring for the center grill emblem on a 66-67 charger . I already have the plastic emblem insert just need the ring itself. They are repopped for around 89 $ fwiw. Thanks, Robert

Anyone know what thread size/type of the inlet pressure side of the steering box uses ? I think its 1/4 sae straight cut fitting but I need to be sure so I can get the right fitting to attach it to a AN -6 female fitting. I think this is what I need but Id like to get confirmation...

The car I'm helping to build is currently in the interior shop and the guy that is doing the 3-d door panels is recommending window cranks and door latches from clayton machine works. has anyone used these on a b-body ?. Their fitment lists 49 and up Gm and Fords but no mention of Dodge these...

Looking for the trim ring hat goes around the emblem on the 66 charger grill also need the small cover plate that screws to the dash below the steering column Thanks

These brakes were on the car when we got it so I don't know what model they came from. the pads look unused and the rotors though rusty don't seem to have any deep grooving/wear. asking 150.00 + shipping from Ft. Worth Tx beware this stuff is heavy Bearings, spindles, rotors, caliper...

I'm looking for the pot coupler that connects the power steering box to the column shaft, I believe its part number 2585335 it has a smaller shaft 5/8" (.630) vs the larger (.760) or so one used on manual steering boxes I've found one for 80 bucks but if a member has one for that price or...

I'm looking for a floor shifter, americanshifter.com has ones for the 545rfe, however their parent company has sketchy reviews and you can't even read their install instructions online without providing an email address. Has anyone used the Lokar 45rfe shifter on the 545rfe ? Thanks, Robert

I'm looking for a trim strip that goes across the rear of the trunk lid just above the back up lights for a 1966 coronet Regards, Robert

This weekend we were able to get the hemi out of the 2005 Dakota and installed the milodon oil pan on the engine. We are using the Schumacher mounts . and we attempted a test fit ( trans tunnel has already been cut out) . We found several interference points on the coronet and were not able to...

I bought a wrecked 2005 Durango with a 5.7 hemi with the 54rfe transmission,for swapping into a 66 Coronet the starter is mounted on the passenger side. But if using say the TTi headers they need the starter on the drivers side. does this engine/trans combo allow mounting a starter on the...

Hello folks, I have recently acquired a 66 coronet project car, Its been tubbed and has a 4 link setup in the rear the body is very solid but has no drivetrain save the rear axle. Originally the car was a 383 automatic with ac. My friend and I plan to install a 5.7 hemi from a 2005 Durango so...