Search results for query: *

Are the A/C lines still available?

Welcome Eric, good luck with your RR, post a few pics.

Should be on the fender tag, my 74 RR was ordered stripe delete, and the data plate reads that. Post your data plate ans me or someone else will decode it for u.

Quarters Still interested in the quarters????

I am interested in the quarters...PM sent.

Wilee Coyote sweatshirt, like new, size medium, black in color, says Warner Brothers Studio on tag. $25.00 includes shipping priority mail lower 48, from 63901. Thanks FBBO.

Very Beautiful car..]

Its a G not a 6 St.Louis

74 rr/gtx My 74 has the standing bird (not in the circle) and roadrunner underneat it, just like the black RR, the emblem on the back of the green RR,is what in on my header panel, my vehicle is orginal from factory, I also have a gtx emblem on the left on deck lid.

Heater Hoses Your 5/8 hose should go to the front, or closer to the radiator. thats the way it is on my 74 RR/GTX with 440

68 rt Your VIN should read WS23L8, the data plate will have the von on it, which should match the #s on the inside of your radiator support, and onthe trunk drip rail under rubber seal, drivers side :hello2:

seat belt latch Bench seat or buckets???

welcome Welcome to the site,iam over here in Poplar Bluff Mo. and have a few mopars myself.

68 coronet rt No they have not been advertized anywhere,but here on this site and another site, at present time I will post pics later. tks

I have for sale a 68 coronet r/t,disaasembled,4speed car,still a roller,w dana,have lots of nice parts for this project,some redone and boxed up,also has two other vehicles that will go with this project,if interested give me a call for more info..Located in southeast Mo..573 429 xxxx. EDITED...

AM/FM Radio My 74 RR has a R35 on the second data plate that is a AM/FM Multiplex Stereo radio, what does your date plate read?????

Not firing on # 2 Did you check and see if you are getting fire thru the plug wire to the plug? If so pull plug and run compresson check on that cyc. you could have a burnt valve, broken spring.

heat Check your pcv valve hose, make sure it is pulling open pcv and not stopped up, make sure where it hooks on carb is not stopped up, i have seen them stop up with carbon buildup and have had to take a drill bid by hand and clean out opening on carb where hose hooks up. Something to check...

Meep Meep I have sprayed some wd 40 in a few of them and let them set, take out the adjusting screw, spray some in there and let set for a few hours.put screw back in and ground and then hot wire it, adjusts as you go, good for a try.