Search results for query: *

Nice build , cars is looking good , I like your hood , who’s hood did you go with , how was fit and finish , I am looking for new hood for my charger

Thanks Moparedtn thats what I was looking for , going to try the Mopar washers and stud kits , thanks again to all for quick response ,

Will try that and follow up later this week thanks

Motor is clean no crude , threads are not stripped or cross threaded , with valve covers on it does look like holes are bored incorrectly, with them off they seem normal , just seems odd ,that’s why I was asking if any one has seen this

No, checked that even tried different length bolts , the head of the bolt does not sit flush on valve cover , from some quick research looks like it might just be the Mopar performance cover , they site flat on the head but I think the top side of cover is not level with the head causing a gap...

Putting my 440 together, and I noticed when installing valve cover bolts that the lower bolts don’t sit flat on the covers , didn’t think to much off it at the time , just put oil in motor and oil is leaking up threw the bolt hole , I am using 440 source gaskets and black Mopar performance valve...

I agree with cosgig , Meyers has a step by step diagnosing procedure on there web site that is very easy to follow , has help me in the past , good luck

I work on cars every day and use snap on tools , they are the best when it comes to wrenches ,sockets , screw drivers etc , but i did just buy a set of icon 1/4 sockets for home garage ,I think for the home hobbyist they are not bad ,I have been using them for a few weeks now with no problems...

I just install quick silver shifter and like it a lot

I recently spoke with Lokar for my 69 charger 727 trans , went with what they recommended for my set up and did not like anything about it , hard to install and get adjusted , did not fit around kick down linkage well and as far as the way it shifted hated it , I took it out right away and...

I was just wondering the same thing , looking for floor shifter that would fit in center console, what have you done and how is it working , I put Lokar floor mounted shifter in and I don’t like it ,