Search results for query: *

Here's a couple photos from this past weekends show, hot as usual but some cool cars & things to see.

Sounds like your on the right track. most likely related to heat issue and too rich! 125 is warm, try checking around manifold/carbs etc. All that aluminum soaks up heat & transfers to fuel. Note: mine was so hot the fuel in carbs basically boiled(vapor lock) not good! May look for thicker base...

Running dual setup on street is tough. Had same problem Yrs ago ran a (b)block w/dual quads,solid lifters etc, had several issues I had to fix! Too hot water temp.( Recore rad),bad vapor lock,(reroute n wrap fuel line)increase fuel psi to approx 6.5. Many adjustments to timing. Leaned carbs down...

Hey 66 satellite, thanks for info. I'm going to take some measurements and look it over more closely. You may be correct!

Hello, anyone have any knowledge whether early 62-65 body have similar torsion bar crossmember to 66 and later? Only thing I notice is bolt holes for trans mount drilled @ a wider spacing than early cars! Not sure about hight,width, length etc. Mine could be repaired but makes sense to put in...

Jt, Not sure when emblem was used . My 64 ply has one on right fender but curious not on left? I have seen this before on a couple other cars but not sure why? Looked through manual could not fit any info!

Appreciate the feedback and detail of your projects. Getting real close to start my floorpan replacement. Door sills /frame rails seem to be in good shape. Looks like most of the damage was caused by water coming in from wiper pivot holes and finding it's way to the front floor area. One...

Thanks for the info, I'am going to replace the whole floor so I believe I'll take the time to brace up the body some before I begin. I agree it's best to be safe.

Thanks 426sfc, After removing dash assembly i found rust damage on lower panel! Any tips you could share when repair is made? Is their a drain area that gets plugged over time and leads to rusting of panels.

Anyone know of a source to find upper & lower wiper cowl panels (right side) for 64 Belvedere? Already purchased LH side from vendor @ Carlisle. Can`t seem to find RH side.

Thanks all, no pics yet haven`t uploaded any. maybe soon.

Does anyone have any advice or knowledge of floor pan replacement? Car is leveled on jack stands with suspension hanging just off garage floor. Body is just about a shell, i need to remove a few more items and it`s ready. But before i start cutting is any bracing needed to support body...

Thanks, appreciate the welcome! going to check out the forum to see whats up!

Hello all, just signed up! long time car guy and gear head! some of my past mopars were, 71 dodge polara 2dr 318 , 69 dodge superbee 4spd bb, 70 cuda 4spd bb .My current project is a 64 plymouth belvedere.