Search results for query: *

Under 2 bucks and delicious

Deadwood tobacco Fat bottom Betty.

Recommend some good ones

Mr Mojo Risin

Pm sent

I filled out Hughes 21 questions for cam advice. I ran across this cam. Any thoughts. Looks like Hughes is selling Hy-lift

Quick question for you. Depending on the gasket I decide to use, I'm looking at a compression ratio of 10:07.1 or 10:34.1. Which would you suggest. Also i will be using a comp cam xtreme energy 274/286 .488/.491

I did forget to add that here but did on the calculator. I will edit my post. Good catch Wild

Using the summit compression calculator Bore 4.32 Stroke 3.75 Cylinder head volume 75cc Effective dome volume 0 Deck clearance. 07 Compression of 9.9:1 Compressed gasket .039 If I did this right, I'm happy with the results. Thanks again for the help guys Edited to add gasket

Looks like the piston is .070 down

Awesome! Thanks

I was noticing that too. 440 source is out and so is trick flow

The only info I could find on the springs said 150 psi. I would like to find a Hydraulic flat tappet cam and reuse the stamped rockers. Eddy performer dual plane, 1 inch tapered carb spacer. 6 quart e body hemi oil pan with hi volume oil pump

Any advice on what else to do to the engine while the heads are off? I'm still looking for which cam to run. I'll be using the holley sniper efi with the hyperspark distributor. TTI 1 7/8 long tube ceramic coated headers into 2.5 inch exhaust. The RR will be a weekend cruiser and not see the...

I appreciate all of the help. I feel much better about using the heads. I will get a more accurate measurement of the piston depth tomorrow.

I've read that the heat disbursement of aluminum heads will lower compression by 1. Any truth to that?

I've had the car since I was 18 but this is the first engine I'm trying to build for it.