Search results for query: *

Does anyone know of an overdrive transmission that will bolt to a 440 and handle the torque yet still live on the street? Thanks

Anyone going to Topeka for Summer Nationals??

What is the dia. or rated stall? Thanks

Yes it is full interior, I had not seen anything showing weights that light, most say 3550 to 3700. How do you like that cam in that comp, that is very similar to what I want to do?

66 Belvedere, 3580# with me and fuel in it, 525" Comp hyd. cam, 850 dbl pumper, thru the mufflers, with 235/70r15 street tires, 3.91 gear and street hemi 11" vert went 13.1 @ 106.8

Wanted to see if anyone help with this problem? On my 440 I got an oil leak (it only leaks while running) at the passenger front of the oil pan, I have replace the gaskets three times and it continues to leak in the same place. Does anyone have any suggestions or might know what I am doing wrong?

66 Belvedere

Hey everyone, I am looking for a 37 tooth speedometer gear, and Mopar has discontinued the part #52068159 and the 38 tooth #52068060. Does anyone have one or know where to get one? Thanks

Been working on it for a little over two years. When I got it it had no interior engine bay was a disaster, but it is coming along fine. 440 with Comp cam, 440 Source alum heads, Edelbrock intake Holley 850, 727 auto with TCI full manual valve body, 3.91 8 3/4 rear end. How about yours?

Here is My 66 Belvedere II at the World of Wheels in KC.

Sorry for not stating this earlier but the car has a fuel cell and the ground is good from the sender. I seen something before about the instrument cluster has to be grounded, is this true? Could I just run a wire between the cluster and a ground under the dash?

OK The sending unit is new and ohm's out correctly and the float floats. The guage worked briefly with the new sending unit, now it does not work. I have also changed the instrument cluster. Any other suggestions? Thanks

I am not very good with the electrical stuff, so why would the light flash on a fuel and temp guage? By the way, my fuel guage is not working I am tring to find out why!:confused1:

OK thanks, could that effect the guages not working? I used a test light on the fuel and temp guages and the light flashes, could that regulator be bad causing an interrupted signal, thus the guages not work?

I was wondering if anyone can tell me what the three prong resistor looking device that plugs into the back of the dash cluster on a '66 or '67 Belvedere, Satellite, is and what it does? Thanks

Anyone going to be in the World of Wheels Kansas City in Feb.? I decided to but my '66 Bel II in the show. Lets hear from you.

Has anyone had trouble using the Energy Suspension poyurethane torsion bar boots? If so what is the trick to getting them over the hex on the bar?

OK, that is what I have been told from others so I think that would be close to right. Thanks for the reply

Hello Everyone, A question about torsion bars, I was given a pair of bars that I want to put in my '66, but what I am curious of is how I can tell which is the correct way to install them. Right from left, front from back, etc.? Thanks

Thanks for the picture, I think this will help