Search results for query: *

I have close to the same combo, engine 493, A&A factory crossram, 2 750 carbs, .620 roller, 4.30 gear, 8" ATI converter, 29.5x10.5 slicks calvert bars. Car weight with me and 145lbs ballast= 3660lbs. This is from this past weekend at Norwalk. As said probably converter

The car should 60ft better than 1.55-1.58. That is where you need to work. With your combo that should be 1.50 or less, I suspect the converter. my 2 cents fwiw

I run autolite ar3911 with good results, same manifold and carbs

Thanks for answering, I am looking at a set and was wondering.

How easy is it to get to the adj. knobs with the tires on?

If you are running a MSD distributor, pull the cap and check the reluctor and pickup. They are known to corrode. Simple check

Here is my take on racing on an indexin NSS, if you want to run a certain index all of the time ex. 10.50 you better be able to run at least 2.5+ tenth's quicker in great air or be ready to dial up to the next index and slow the car down. It's much easier to slow the car down than to pick up a...

Add an extra clamp to the front section of the springs and as mention earlier long 50/50 shocks. Now if you decide on running radials tires, double adjustable shocks will be needed. Get it out and have fun, should run really well.

Wonder what the ET difference would be vs the -200da? This was the Mopar Madness race.

Line lock- on rear brakes? Wouldn't you want it also on the front brakes along with a 12vdc timer to be able to leave like a transbrake/delay box car??????????? Especially in a footbrake class. Asking for a friend.

My two cents, you need more compression and cylinder head porting to get where you want. My cranking compression is 215-225 psi with 272/276 camshaft. My heads are 65cc's and with flat top pistons about .015 down the hole.

I haven’t raced any dyno’s, so curious what ET difference will be.

The story goes: Indy 440-25 is 90 - 100 HP increase over factory crossram. We'll see........

Tape the allen head socket to the extension. Shine a flashlight down the carb mount to help guide the bolt in. You may want to put a little pipe dope on the bolt threads so oil doesn't weep into the intake. Torque to 35 ftlbs.

lay the dipstick across to help keep the pushrods in position

It's stamped on the intake right above the hole. Or 2- 2", 2 - 2.25", and 2- 2.50"

Little EZ 295

My combo is back on page 4 #63. I run TTI 3" X-Pipe and magnaflow mufflers 99.9% of the time not trying to set any personal best, just seeing what changes pick the car up and how much. This time slip was with 50lbs of ballast. Low maintenance car. I had the tranny freshened this winter and ATI...

60ft has really improved, wonder if it's mostly from the larger nozzles? Good job. You've got the 11.00 index covered now, should be fun