Search results for query: *

Do you now have some type of heat barrier in place to help shield the engine harness from impeding heat? I am going to start replacing components. Knowing if there are specific products to look for or knowing how to protect them from heat would be good info to have.

Yeah, I am seeing that it is a collectively agreement from all on this thread to have backups to the backups when it comes to parts prone to failure. I do not have the electronic setup. However, I will take a line from the provided info, "Defective components cannot be repaired, but must be...

Good point!

At this point in the season, I am testing every angle. Thanks!

Roger that. I will check the wiring diagram. There are a couple of hanging wires that I need to resolve.

Awesome advice! I will check this evening after work. Is this type of resistor found in a local auto parts (i.e. NAPA) store, or do I need to go ahead and make an online order? I want to disconnect the battery and re-connect the wire on the left. My concern is blowing something and push me...

There's a lot of great information in this forum. I apologize if this question has been addressed already. I have a '69 RR that I just had a 440 put into. She has been running fine until last week when she just cut off on me. Luckily, I was on a street where I could coast to a turning lane...

I have the same small DIY project where I want to switch from a 383 to 440 emblem on the hood scoops on my '69 RR. My issue is that I do not know how to remove the 383 set. How can I gain correct access to the backside of the scoops? The Air Grabber mechanism has me perplexed. Here is a photo...