Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
X2 on the Formica.
Mine's held up pretty well so far. Basically made the bench tops the same as kitchen counters. Glued the Formica with that nasty yellow contact cement & used a router w/ a laminate trimmer bit to run around the top to make a nice square edge (good for bending sheet metal...
Thanks!
I overlapped about 1/2" for temp placement (you can see 2 cleco pins in the middle of the panel in last pic), then I traced the top of the new qtr edge onto the green tape on what's left of the original panel. Just before final welding, I trim back on the line & use the 2 clecos at the...
A long time ago I built a model of a Savoy I fell in love with from an article in an old Hot Rod. Funny thing is, the article photos were in B&W so I never knew what color the interior was. I figure it was probably red or that funky gold, but for some reason I pictured it blue - so that's the...
When driving on a multi-lane highway, I never change lanes with another car abreast of me one lane over. Inevitably, the other guy will pick that exact moment to try to occupy the same space at the same time. I either speed up or back off. It avoids doing 'da bump'...
Like you Pabster, I give...
I usually play with Holleys, so some of this may or may not apply...
I think you're right about exposing the transfer slot. In general, if your idle speed screw is turned in too far (i.e. opening the primary throttle plates too much), you'll be past the idle circuit ports, so the mixture screws...