Search results for query: *

Haha! Makes it a bit hard to go through the maccas drive through, but small price to pay for owning a real car.

Not sure if I am understanding you correctly but here goes. 2 posts on your starter motor, 1 is a big fat one for your 12V battery feed. Second is smaller for your 12V exciter feed from your cranking circuit. Run 12V heavy gauge battery wire to the big post. Run your small starter motor...

Mate if it helps, I got the SSBC kit for my 68 roadrunner, just with the standard disks and 4-pot calipers (no drilled or slotted). Cost me around $600 here in australia. It comes with an 11" booster I think and brackets to mount it. The iron master cylinder is complete junk though. I have...

Mate I feel your pain, and then some!! Isn't it amazing how you budget out your build, then find yourself breaking the bank on the small things like AN line and earls fittings!!! i will get some photos over the weekend once I get started on the trans cooler. AN line isn't cheap but I guess...

Sweet build man! Very similar to the setup I am doing in my 68 roadrunner! I have TTI headers and edelbrock victor heads on a 522 stroker. Not sure what your plan is for your trans cooler, I am in the process of sorting mine out at the moment. I bought a B&M cooler which comes with 6AN...

Thanks for the reply mate! I ended up grinding a bit off the bracket so it sat nice and snug against the pan, was able to bolt it up nicely. Adjusted the cable and checked all of the adjustments and it was sweet. Shifts nice and smooth too! I ended up mounting the cable on the under side of...

Hey all! Have done a fair bit of searching around to see if anyone else has had this problem, but havent had any luck! I have a fully rebuilt 727 torqueflite with a reverse pattern manual valve body. It also has the TCI deep cast alloy pan on it. When I am installing the cable bracket for the...

I made some measurements over the weekend and I'm fairly confident there will be no issues. From the wheel mounting surface to the nearest inboard point (leaf spring) is 6.5". From the mounting surface to the nearest outboard point is 7". So I figure I will run a 15x10 with 5" backspace, which...

Thanks so much to everyone for the replies! That makes plenty of sense. I am thinking I will go with the 15x10 convo's with 5" backspace and 295/50/15. I had pretty much decided to ditch them and go for a 15x8 and a 275 instead, but with the 522 donk going in I think i need as much rubber as...

Dennis, What backspace you running mate?

Thanks for the info. Currently I have 275/60/15 on the car, not sure of the offset. They fit fine, I rekon I have a good 1" clearance on the outer wheel well lip and probably 1.5" between the tyre and the spring. Might make some measurements to be sure I think... 285's could be a good...

Hi all, I hate to be one of those guys with a "will this fit" question, but I need some guideance. I have done a lot of research into this already but I have an issue with what rims I can get my hands on here in Aus. Basically I want to run a 295/50/15 Radial TA on the rear of my 68...