Search results for query: *

Looking for 65 727 cable shift torqueflite slip yoke tailshaft and housing. PM me here. Thanks.

Can’t you make a second one so they match? Maybe paint the center with argent wheel paint? I’d bet nobody could tell the difference or even notice.

I vaguely remember seeing that somebody reproduced that piece out of solid aluminum awhile back. I did a search here but didn’t find anything. I would think Bill Petrow would know something about this if anybody. I’m no machinist, but it looks like it wouldn’t be that hard to fabricate out of...

Looking for 50s Chrysler key blanks, different from 60s and 70s. The keys on the left are what I’m looking for, notice that the slots on the sides are different. Also slightly shorter. For a 57 Dodge D100. Thanks.

Are the spindles different for 10” brakes? I may have a pair of them.

Salt grass goes through me like grease through a goose. No thanks. Hope you find who you are looking for.

I’ve got one of those cheap cast thermostat housings that seeped coolant. I bead blasted the cheap chrome off it, it gave the housing a texture that the gasket could “grip”, it was just too slick to seal. It hasn’t leaked since.

Do you need just the radio? I think I’ve got a 63 radio, but I don’t think it has knobs. Not real sure if it works, been sitting on a shelf for the last 30 years.

65satelliteman had a set awhile back, you might try him.

Look up A&A Transmissions, Camby Indiana.

They are different from side to side.

Are those 10 inch?

I got one from Napa a few years ago, wasn’t very expensive. Comes without the lock.

This guy...

Nick, I apologize for not getting back to you. I’ve just been busy and haven’t had time to look. I will look tomorrow and get back to you. Sorry.

PM 65satelliteman, if anybody would have them, he would.

I’ve got a can full of radio stem nuts. If you’d have a picture or dimensions I could probably match up something. Maybe not 100% factory.

They repop the horizontal trim piece, not cheap. Good luck trying to find a good used one. Try this guy.

The box I used was just big enough for 1 hub, don’t remember the weight.

I shipped an early B hub to another member recently in a USPS flat rate box for a little less than $20.