Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
After pressing out the pivot pin and getting all the old rubber out, if you have access to a welder, you can weld a washer to the outer shell and press against that to het it out of the LCA. I do the same the the inner piece that is still stuck on the pivot pin.
Is your press big enough to set...
Usually a good solid smack with a hammer will work to separate the ball joint from the spindle if a pickle fork is not available.
Upper ball joints can be tight sometimes. For stablity, you can turn it loose while it is still bolted to the spindle.
Take the snap ring off the back of the...
In the attached image I see no voltage regulator at all. Just the wire kind of hanging in the air near where it should be
- - - Updated - - -
Then again, you got no spark plug wires either.
The main thing to look at is the valve covers. They have the raised part that comes to a point in the middle and the lower edge is not straight. If you had a poly 318 next to an LA engine you would be able to see the world of difference between the 2.