Search results for query: *

Prime rib and lobster, just for me.

Looks like Alex Lifeson's doppelganger in the left. That looks like Curt Russell seated at the table, top right.

My carburetor couldn't tolerate the high output pressure of the chinesium Carter fuel pump ordered per the Rock Auto catalog. My 67 440 with the 4327S Carter carb wants no more than 5psi (per the service manual). I had a bad flooding issue with gas all over the intake. I rigged a regulator and...

I am looking for rear speaker switch (pot) for dash with chrome knob.

This makes your scope useful ignition_waveforms.pdf https://share.google/i21Vl9BDLdopCYaPJ

Kinda back in action! Fuel pump died, finally got it replaced , best way to test it is drive it, so off to the grocery store, and Oreilly’s where she found a friend .

Looks good to me. You have it triggered and capturing a waveform that's 728v p-p. You can change the time base and zoom in on the ringing. Somewhere I have a link to a white paper that explains how to use a oscilloscope as a ignition system analyzer. You use clothespins, foil tape, and 0.01uf...

I agree that the tapered are superior to any non adjustable replacement but these are not fragile and do not suddenly fail. As bad as I push my car, if they were junk, they would have failed sooner. Starting from scratch, I’d go with the stock type. If you already have the ball bearing types in...

Check the bottom of the gear box and see what you find besides the broken teeth. Maybe a needle bearing or something was dropped on accident by the rebuilder.

Bust it apart and assess what's messed up. If the bearings are toast, you'll need them along with the inner and outer seals plus the collars that press on after the bearing which helps keep the bearing in place. There is also a foam gasket and a stamped steel gasket on each side. Timken...

Close. Hairy, burly and Mopar. A clean 60s C body. Rain on the horizon. Radar Doppler on the phone showed a cell south of us…, Only once, maybe twice have I seen rain at the big California Spring Fling show. Oddly, it cooled down, rained for a bit, cleared and felt really nice. Back...

Hey, that's Greg! On his left is his brother Mark, on his right is his other brother Mark.

A couple cars I really liked

Thanks guys!! You pointed me in the right direction and I found them in the assembly manual.

3M panel bond will fix it, rough the bonding surface a bit clean it really well and it will never come off again.

With all the fake news these days, the only thing I believe...is the Bible

Yukon Gear has a bearing, seal, retainer, adjuster package. Timken bearings in the package btw. Scored one to replace the Greens installed by the PO. Since I'm not sure if he pulled the buttons out of the carrier, I bought a set of those too in case they're needed when I take it all apart.