Search results for query: *

I'm needing a fan shroud for my radiator to keep the heat down a little bit. Right now my set up is a 26" Champion radiator with clutch fan and it gets a little dicey when I'm in traffic. Thanks.

I only need one but will take whatever. I'm trying to get the car finished for a 4th of July car show. Please help. It's for a '69 b body and the part is those little rectangular nutplates that hold the two screws for the armrest/base assembly to the door.

Apparently my shift linkage is not the right one. I don't have any where to adjust the linkage and per the FSM there should be a screw that the lower link can slide in and out of so you can adjust it.

Does anybody have a good new or used three prong pigtail I get get off you. I've been calling the local dealers and they don't have them in stock plus they want $53 plus shipping for it. The one I have on the car now is an aftermarket pigtail and keeps slipping off and is made of a hard plastic...

I need a two groove crank pulley for my engine (383). I know I can get one new from 440source but before I shell out that much money, I just wanted to check if someone has one laying around. Shipping to 84067

I just need one of those little black clips that snap over the heater cables under the dash. Shipping to Utah 84067

How I always make an easy job into a hard one is beyond me but after spending an hour trying to dig my spacers out from between the quarter panel and frame piece I've officially given up. Does anybody have a pair of those spacers that the pivot for the quarter window regulator goes in on the...

Hey guys I need a 33 tooth (yellow) speedo gear, willing to buy or trade. I have a 26 red speedo gear and a 31 green speedo gear.

For whatever reason one of the reflectors I have is the wrong one so I need one or two if you don't want to split up the pair. It'll be for a '69 Roadrunner, it's the rear (red) one that I need and would need one that can be easily polished with no deep scratches. Thanks.

Anybody have a really good or just good headlight trim ring for sale. My buffer decided that one of my rings were entirely too round and liked it better looking like a pretzel. It's for a '69 Roadrunner but I'm sure there are tons of cars that use the same rings. Shipping will be to Utah 84067...

Looking for a decent set of upper control arms for a '69 Roadrunner. Hopefully there is a pair out there that aren't too rusted. Mine are bent so there is no saving 'em

does anybody have a good door handle button hinge. I'm guessing at what it is called. Its the piece that the post attached to the button for the door handle presses against to release the door. When I was cleaning mine the spring on it broke :crybaby2:

I'm talking about the one that is spot welded to the driver's side floor underneath the car. It's for a '69 Roadrunner, I'd also need the location to where it goes since my bodyman who's skills are better than his brain forgot to take it off before discarding my old floors. If anybody has one...

Mine's a little bit out of round and I'm worried it is going to give me problems once installed. Does anybody have one for '69 Roadrunner, '68-70s work I believe.

I was wondering if anybody has a set of bumper brackets they could sell me. One of mine are bent so I don't really need a whole set but if anybody that has them and are unwilling to seperate I'll take it all. I just don't want to run into any problems when I try to line up the bumper straight.

I need the kickdown linkage for an automatic 727. I'm not sure if it matters what motor I have but currently there is a '78 400 block stuffed in it but I have a '68 383 sitting on a stand. I have the upper rod and link but I still need the center and lower rods plus the link between those two...