Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hi,
I'm looking for the wiring harness which runs from the heater box on my '66 Coronet to the dash mounted switch. My car came without a heater which I have since found, rebuilt and installed. The repop houses don't seem to have this so if you can help me out, please send me a PM.
Thanks!
Joel
I'm looking for a driveshaft for my '66 Coronet, small block, 4 speed with 8 3/4" rear. It's 29/30 spline up front with a 7290 yoke at the rear. The shop manual calls out 2.75"X52.28" for the shaft proper.
Would like to go with the larger 7290 bearings all around if that is possible.
Located...
Looking for a pair of Lower Control Arms for my 1966 Dodge Coronet 440, ready to install. With or without front sway bar mount. Please contact*********** via Private Conversation here.
I am looking to install my newly acquired engine into my 1966 Coronet. The engine has block part number 53020006 which started out as a 360. The K member installed in my Coronet is part number 2962090 (90 on the coin). The car previously had a 318 installed. Those mounting brackets to not...
I am looking for the right hand vent cover/grill for my 1966 Dodge Coronet. I bought the heater box on this forum which was in great shape however UPS managed to mangle it even though it was well packed. I repaired all the damage and got the box installed with a new core. The only part I...
I'm looking for a pair (left and right) Headlight Splash Shields for my 1966 Coronet 440. Whoever had the car eliminated them somewhere in the past. I don't have a picture but from what I can see under there they bolt in, 5 places each, and have a number of holes for the seal/weatherstripping...
I’m looking for a pair of 41” torsion bars for my 66 Coronet. Anything thicker than the .86” set I have, original to the car (it was a slant six). Prefer .90” or .925” verses the .88” version if possible. Please PM if you can help me out. Thanks, Joel
I'm looking for two (2) decent front struts for my 1966 Coronet 440. The ones I have are no longer straight and are a bit mushroomed where the collar rests up against the strut. Guess they are vintage 1966.
PM me here please if you can help me out.
Thanks,
Joel
Hi,
I'm looking for the under hood wiring harness(es) for my 1966 Coronet. This is a non-AC car. My main concerns are for the ignition, alternator, regulator which have all been cut into and spliced all over the place without regard to color coding. Some wire runs change color 3-4 times with...
Wanted, A reasonably complete non-ac heater box for my 1966 Coronet. Heater core if available. Either in tact of repairable is acceptable with as much mounting HW as is available.
Please PM me here.
I'm located in south Florida