Search results for query: *

what is the torque setting for tightening a Thermoquad on a 1972 340, with stock 5\16 in gasket

Thé 360 i have has a vibration above 3500 rpm. I’m running a stock cast crank (3418649)with stock 360 flywheel and damper. I’ve Noticed metal added On only 1 throw of the crank. Front throw seem to have been machined. Do it look like a crank modified for internal balance? Also the engine is...

The cam currently in my 360 is an old mopar Purple shaft cam. https://www.summitracing.com/parts/dcc-p4452992ae That engine has ported X cylinder heads, 9.75 -1 compression ratio. headers, stock intake manifold and thermoquad. (Air grabber). 3.55 rear gear, 4 speeds. what would be a nice...

i have a .030 over 360, 9.75 to 1, ported X heads, P4452992AE Mopar purpe grindcam, .477 lift, headers, stock 1972 intake manifold and an 600 cfm Edelbrock carb. Mopar electronic ignition,20 initial, 35 total. Engine pull hard, idle is fine at around 900 rpm. But, it smell gas and tailpipes are...

Looking for a "Quality" shifter boot for my 1972 Satellite bench seat. Any suggestions?

My argrabber actuator is leaking from the shaft so it's slow to open. Do you know a source for that seal and is-it difficult to change?

Hi need a picture of installed shifter rod for a 1972 "B" bench seat 4 speed? I'm installing one in my 1972 Satellite and i want to be sure i'm using the right shifter rods. Thanks

I'm building a 400 B engine for my 1972 Satelitte, A833, 3:55 gear. It's going to be street driven a lot and was thinking of a stroker , mainly for torque at low rpm. What will be best for a street driven car, 451, 472 or 500 ci.? Which one would last longer? Also going to use original intake...

What should be the driveshaft lenth for a 1972 Satelitte Sebring, sb, A833, 8 3/4"?