• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. Moparmayhem

    Broken water pump housing mounting tab on our 440

    Please see attached picture. We bought the block like this thinking we can get it fixed?!?!? Turns out to be a pain in the rear. We would like to get some thoughts, ideas or directions on how to remedy this if at all possible. Thank you in advance
  3. Moparmayhem

    Low compression on rebuilt 440

    We have a rebuilt 440, .010 over new pistons and rings, with new heads, lapped valves, mild cam, and hyd lifters. We rebuilt this a couple years ago, (I know, not a good thing) and kept priming the engine with a drill to keep everything oiled. It is now mounted on our run stand and getting ready...
  4. Moparmayhem

    73 440 RB Flex-Plate Question

    I have a 73 440 RB, forged crank and want to know what size and tooth flex-plate I should be using with a 727 Trans. Thanks in advance,
  5. Moparmayhem

    70 charger rear end fit 74

    How's everyone doing. I am looking for a 8-3/4 rear end for my sons resto project. A gentleman said he had one but out of a 70 charger. Can anyone advise on this please. thank you in advance, Moparmayhem
  6. Moparmayhem

    Ø3/8 push rods rubbing Stealth heads

    Hello, We purchased some Stealth heads and a new set of push rods (solid) and found out they rub on the casting. I was wondering if I can have the push rods machined to Ø5/16 in that area or should I take the heads off and open the holes? Thanks for any help, Moparmayhem
Back
Top