• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. mopar440bbody

    orange box out again should i convert to GM module

    what GM module to use on a 440 to convert to GM ign. this one is for sale at o'reillys ............. Warranty: Limited Lifetime Warranty Unit of Measure: Each UPC: # 91769018009 Terminal Type: Blade Connector Gender: Male Number Of Terminals: 4 Terminal Gender: Male Voltage (V): 12...
  2. mopar440bbody

    well just my luck burnt up fuzlink bypass

    after new volt reg and a volt gage install took 67 out all was ok been watchen volt gage charging very high like 17 plus when at 55 . but with a load test using all electrical function on car volts drop to 13. .5 ............... so i smealded smoke the bad kind wires burning up so link is fried...
  3. mopar440bbody

    volt gage 17+

    hey please read other posts on voltage issues;.........however had voltage reg tested and it failed so i got a new one and installed it with a good ground to the motor. and checked all connections. my factory harness is in good shape as far as connections goes. factory terminal on alternator...
  4. mopar440bbody

    rechecked

    well i had battery test at napa and oriellys and they say its a good batty. 771 cca on load teat.............. alternator output up to 12.9 at high rpms.................took car out this morning for gas and drove about 25 mins and about 20 miles but on return to home no bleekers and so ni loaded...
  5. mopar440bbody

    alternator output

    hello i have had a flat battery for last few fews so i pulled the alternator had it tested and found it to have a bad bearing and the output was about 11.58 on store tester. i have install a new liftime napa alternator and the output at battery is 12.26 and when testing just battery level is...
  6. mopar440bbody

    setting timing

    hello, been out of the game since 2003. just got a 67 coronet w/440 with slight build. so as i dont know much about this motor. it does have a small cam and 40 over pistons with eldobroch intake and carb 650 i think. test drive it never missed a beat. it has a b&m floor ratchet shifter, if...
Back
Top