Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey guys,
I ran through the installation manual for my MSD ignition system looking to find how many amps fuse i should install on the 12 volt power supply.
I ran a wire direct from battery, through a relay that switches on by the original ignition wiring, to feed the coil with 12V direct from...
Learned a new thing, never heard about it before...spark plug side gapping.
I had read up about it in several articles on the web, seems like there is not a real gain as statements like +10Hp or anything like that; even then that is not what i was looking for.
But it does tell how the flame path...
Hi fellow Mopar fans,
I have done some work on my 440 engine over the winter and all is just back together and i have been doing some test driving.
I am busy with setting up the carb and ignition for a happy medium, today i decided after done some miles to check the spark plugs.
The electrode...
Hey guys,
Today iv'e tested my 3 speed wiper motor which i want to install on my car.
As i have all the dashboard out i hooked it up to the dash switch for the wiper with some jumper wires.
I double checked the pins on the back and the wiring colours and hooked it up as per diagram.
All colours...
Gents,
I need some urgent advice on a tach adaptor to install for my tic toc tach on my '69 Coronet 440.
Recently a Ready-To-Run MSD 8287 distributor and a MSD Blaster SS coil 8207 were installed which is working very good btw.
Obviously the issue as many others found is that the tach is no...
Hey all,
Today i've removed and cleaned up the connectors on the fire wall.
I've found the black wire to the Amp meter badly corroded and the crimped socket broke off.
I measured resistance to confirm i cut the correct wire (near the ignition block) and already measured a lot of resistance...