Search results for query: *

Ok I have a 1968 Superbee with a 383 Auto. I have replaced the Carb with and Edlebrock 650 with electric choke and just upgraded the distributor with and electric Mallroy. The problem I am having if I punch it it falls and it face (like the engine cutting out) then the carb does a little...

I have searched the forums but could not really figure this out. I have a 383/727 combo in my Superbee. I have replace the carb with an Eldebrock 650 Thunder Series and it run pretty good but will stumble off the line and then go all out. Now I see there is another ajustment for the accelerator...

I thought I had this fixed but it blew the fuse again. I am running a 25 amp fuse. Should it be higher than 25 ? I replaced the voltage reg. and things seemed to be good until yesterday when I reved the car and it blew the fuse again? Any thoughts? Thanks 1968 Superbee 383

Hey guys I just finished installing my gauge cluster and found my fusible link to be bad and it had a 25 amp fuse in it. I have now changed it out and was using a 20 amp fuse which keeps blowing but only when I give it a little gas to rev the engine. I did notice the amp gauge spike right before...

Can this be done? I asked this in another thread and think I have seen the same question but thought I would ask. This is in a 68 Superbee. Thanks ahead of time. Jim

I am having several issuse right now but will try and take one at a time. Is there a way to test the wiper motor without the switch with just using the harness at the firewall? I just want to see if the motor is good and go from there. BTW thanks for all of the help 70rr-brian and everyone...

I have no power to anything on the dash. I have been told that the circuit board to the rally dash to my 68 Superbee was fried but nothing else works loike the heater or wipers. Is there a main that feeds everything that I can check. I am just starting to trouble shoot this but thought I...

I bought a Rally gauge for my 68 bee years ago to install. With life changes (divorce)and yes I still have the car it never was installed or tested. AS I was told the gauges in there now do not work as the circuit board is bad. Is there anything I should do before installing this new to me...

I have a 68 superbee with a 383 and I have just replaced the starter and I am having the same problem. I go to start the car and the engine turns over but not really like clicking very fast then it kicks in and turns over fine. Could my ignition switch be bad as it seems like it does not make...