Search results for query: *

This could be posted in either "Interior" or "Electrical", my apologies if it's posted incorrectly. I want to detach the clump of wires on the interior where they attach to the firewall so I can remove my instrument panel ('70 Charger). I see no screws, on either inside or engine-side. On the...

I'm going to see how much I can improve my original white '70 Charger upper door pads. Before I re-dye them black, please share your ideas on filling some of the bigger cracks in the vinyl. Thanks!

I'm wondering how to finagle my repro cardboard glovebox liner into my Charger--without damaging it. I can get the left-side flap over the fuse block and get it jammed in about halfway but it's fighting me all the way just to get to that point and starting to bend & deform. Got any tips? Slide...

I got some polyethylene sheet drawn up and cut out for the front door water shields, those went in fairly easily. The old glue lines showed me where to apply the fresh butyl tape, pasted the sheet on and tucked it in at the bottom groove. However, the area below the quarter windows under the...

I found this laying on the ground under the car yesterday. I believe it's to secure one of the shift linkage parts. I'm guessing the vertical rod to the left of the shifter assembly that goes through the floor to the transmission? I'd already used cotter pins to secure the linkages.

Over a decade ago, I was talking to a coworker in his office and noticed this shifter sitting on his table, that I recognized immediately. This guy had a 30-something hot rod so I asked him what the shifter was for, because it was similar to the one in my '70 Charger. He said a friend gave it to...

I have most of my Kilmat deadener installed and will soon be putting in the new carpets. Quick question: As the rear carpet goes in first, where exactly should I position it before the front carpet goes in? A few pics of the correct position would be great, and show the correct amount of overlap...

I had the seat frames out of my car for restoration and upon reassembly, I noticed only the driver side frame had this thick beefy spring, in addition to the small yellow outer spring for the adjuster lever, and the cable that joins the adjuster levers on both halves. However, the passenger side...

I have my '70 Charger seat brackets sandblasted. I don't need these to be perfect restorations, just look good and be durable. What are some recommendations for: 1. Cleaning out the old gritty grease 2. Prep & paint 3. New grease - what to use? I was thinking to spray SEM Trim Black on the raw...

I just ordered a black headliner from RPM in Saskatchewan for my '70 Charger. P/N: HA977BLK for black. Their catalog shows this to be a Charger-specific headliner, and I've found RPM to be very accurate with parts I've purchased before. What I received was a '68 RR/GTX 6-bow headliner; P/N...

I've read that others on here have installed ProCar seats with their Mopar adapters and things went nice and smooth, but I'm seeing a lot of reviews saying the fitment isn't even close for a '69 Charger. Mine is a '70 so I assume the mount holes are the same. The adapters are P/N's SCA81342 and...

Here are the original vinyl seats in my '70 Charger, currently almost done in body & paint. I've had them out of the gutted interior for almost 2 decades and pulled them out of my storage shed to take a closer look at the condition, as they will need to be, at the least, recovered and possibly...