Search results for query: *

I have a 73 charger with a 360 engine bored 30 over with stock pistons rpm intake edelbrock heads with a crane 272 cam edelbrock rpm intake 750 vac. holley carb,hooker headers and 2.5 exhaust ,with 323 gears and a tci trans, with a 2000 stall. car runs great but there is no get up and go coming...

I started removing my dash so that I can send it off to be repaired. got it just about out but the wiring going to all the lights and gauges seems to be a problem what do I do to get it all the way out? Is there a main plug or do I have to try to tag each wire which is going to be hard to do. I...

I have a 73 charger that is in need of the gas gauge repaired or replace. I have replaced the tank sending unit twice so I don't think it's the sender. the hand was going to full if you added 5 gallons to the tank. Now the hand sits in the empty location and jumps back and forward. I don't know...

I have a set of edelbrock heads with a 600 lift with dual springs on the heads in a 360 engine, I have plans to install a bigger cam in the engine this fall, I have comp cams in my other cars and I have single springs on the heads but I have noticed that comp cams want you to remove the inner...

What do you need to do to get the door to close after replacing the weather striping around it,I have to slam it to get it to close.It has been on the door about three months and still will not let the door close unless I slam it. need help.This is on my 77 Camaro. not the charger.

My 73 charger have a problem with starting once I drive it and get it hot about 165-175 degrees. If I shut it off and start it right back up it starts, but If I let it set about 20 minutes or longer it will only spend over but will not fire.I have changed the control box and coil but It still...

I am one of those guys that want as much horse power I can get from my engines,I have 1 inch spacers that I have removed from engines that I felt did nothing for me performance wise but I have been told that they help with horsepower and torque. If so how much?

I have a bored 360 engine with Eledbrock heads a small crane cam 454/480 750 holley, RPM intake and headers. The heads have a 600 lift max. I wanted to increase the cam lift using the 1.6 rockers if they make them.The car also have a TCI trans a 2200 stall and 323 pos. rearend.The car runs great...

I have a 73 dodge charger that have a problem with the gas gauge. It works but it goes all over the place unless I put about 5 or more gals. in it than it stays on full until it runs the gas down to a point, than it goes back to the moving from empty to whatever it decides to do. I have...