Search results for query: *

My friend just bought a 1987 ram 250 3/4 ton. It is a 318 2 barrel. It starts and drives ok, but wont kick down when you tramp on it. I am thinking the kick down rod may be mis-adjusted. The real problem is that it wouldn't accelerate. It just misses and hesitates real bad. I had to drive it...

Hi there, I currently have a 600 holley vac secondary on a built up 440 .455 mopar purple cam, 8.8 compression engine. Torker intake 906 heads. The engine runs great bottom end acceleration to about 60 or 80 kms. At higher speeds over 80 km, when I kick it down doesn't feel right, plugs say it...

I have a big block 727 tranny in a dodge ram. With the headers and kickdown cable it is tight in by the tranny lines. I have brass fittings on there now with rubber hose. I then double clamped that to 3/8 hardlines up to my tranny cooler. I had one of the tranny lines pop on me a while back...

Just wondering if anyone knows what size the rear main seal cap bolts are on a stock big block. They look like some 12 point 9 or 10 mil? Not sure if I have the right socket.

Is anybody using the 440 source aluminum valve covers? Just wondering what people's opinion on them are? My stock stamped steel ones with rubber gaskets are leaky old junk. I'm also a bit concerned for height for the application of the engine. Might contact the brake booster. Anyone have any...

I rebuilt a 440 to .030 over with mostly stock parts. stock replacement pistons 906 heads .455 purple cam and torker intake. I have a edelbrock 600 carb on it right now. The problem I am having is I am trying to run it to break it in on a home built stand. The ignition only fires 2 cylinders...

So my 440 is almost done at the machine shop and I went to the parts store for some bearing lubricant/grease and a cam break in grease. Nobody knew anything about it. The guy says" Whats it for a chevy or something" O boy. They said use lucas oil stabilizer on everything. Finally a guy went to...

i have a internally balanced 440 im building. i need a flexplate and torque converter. will a flexplate off of any 727 trans work? and will a 318 converter work ? or any 11 inch converter with no weights on it?