1964 Plymouth power steering pump

[justjim]

i am currently rebuilding my original power steering pump and what do i put on the 4 1/2 inch rubber o-ring that goes onto the housing and the canister as far as a sealer ? right stuff or just some type oil/sealer ? PM me your thoughts 1964 Plymouth Fury

 

[jimbosride]

I sent my 1964 pump out for a full rebuild. If I remember right it was quite reasonable on cost. It works great.. no leaks or issues. If you want more info let me know.

 

[R413]

No sealer needed. I put a small amount of PS fluid on the can and surface of the o ring after it is in the groove, just so the can will slide on. Zero leaks.

 

[justjim]

No sealer needed. I put a small amount of PS fluid on the can and surface of the o ring after it is in the groove, just so the can will slide on. Zero leaks.

GOOD to know THX

 

[justjim]

I sent my 1964 pump out for a full rebuild. If I remember right it was quite reasonable on cost. It works great.. no leaks or issues. If you want more info let me know.

there’s a place in Minnesota quoted me $250.00