FOR SALE 1966-1968 Hemi crank pulley, 2 groove.

[Cop car wagon]

I got this with a car, and cannot confirm if it is a new repop, or an original that was powder coated. I've had the car it came in for 20 years, and it was parked for 10 when I got it. Its been on the shelf, and when I went to use it, it did not fit my 440. Did they even make repop back then?
No pitting, at all.
I am leaning towards original as there are lock washer marks under the powder coat. Plus you can see they coated over dirt in the pocket. ( last picture)
1 3/8" to center of back groove, 2 9/16 deep overall, 6 1/4 diameter.
$170 plus shipping

 

[gpv440]

I have been looking for this pulley. I can't tell from your pictures if the front groove is for a 1/2'' belt and the rear for 7/16'' belt. The pulley I have now has a 6 5/8 dia. front for the PS pump and 6 1/4 for fan but the other measurements are the same as yours, not sure mine is correct because I can't get the power steering belt on without removing pump. If the front groove is wider, then the back groove I would like to buy your pulley.

Thanks

Tried sending you private message but your box is full

 

[Cop car wagon]

Both belt grooves appear to be the same width. I grabbed a new 1/2" belt for pictures.
I am not a hemi expert, but I thought they ran a 3/8" belt on the power steering , but in a 1/2" crank pulley groove.
Maybe someone will add ibfo.

 

[gpv440]

Thanks for updated pictures.
This is on my 68 HEMI RR. I ordered a reproduction from Mancini that was totally different wish I would have taken a picture of it before I returned it.