• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

WTB 1966 Belvedere heater control knobs

Status
Not open for further replies.

TonyB

Well-Known Member
Local time
7:38 PM
Joined
Jul 4, 2012
Messages
177
Reaction score
26
Location
Minnesota
Feedback: 0 / 0 / 0
Still looking for chrome knobs for heater controls on a 66 Belvedere.
 
I don't there are any that came OEM. My Satellite's are black.

If you take chrome centers out of some upper knobs .
 
Last edited:
Ok, I never had any in this car or the parts car, I just assumed they were chrome. Black will do, I have nothing now. Thanks.
 
I'll admit I never looked to remove mine but aren't they molded onto shaft?
 
Do you have a picture of what they look like. I have no clue. Are there set screws that hold them on?
 
If you don't have any you should go to Mopar car parting and buy an assembly ask for screws that mount to dash come with them. There a 66 Belvedere and a 66 or 67 Coronet (same part) for parts in parting out.
 
They seam to be cast on to shafts like headlight knob. Note the hex head screw that holds them to bottom of dash. the right hand pull mount on lip of dash below ignition key.
vp1.jpg
vp2.jpg
 
Are you looking for the small black press on knobs that go on the heater control panel that slides left to right? Heat, defrost, etc? Or the chrome looking discs that mount in the center of the pull knobs under the dash? The under dash pull knobs are black, the switches, like the headlight switch, get chrome centers, same as radio knobs, chrome centers.
 
I am looking for the black plastic that go on the sliding controls for heater/defrost and Cold/Hot.
 
Status
Not open for further replies.
Auto Transport Service
Back
Top