WTB 2 Groove Crank Pulley

[ibsorgn]

Looking for a 2 groove crank pulley for my 440 motor. Presently running ps on outer goove and WP and Alt on inner groove. My current crank pulley is twin groove 5.2 inch aluminum reduction pulley which I fear is not spinning the WP fast enough to cool the motor in hot days with slow moving or stop and go traffic. My WP pulley is a single groove aluminum 6.6". May consider purchasing both pulleys.

 

[Randra]

I have this one available. It's around 7 1/4" diameter. The inner Groove is around 6 1/4"

 

[ibsorgn]

View attachment 348874 I have this one available. It's around 7 1/4" diameter. The inner Groove is around 6 1/4"

View attachment 348873

 

[ibsorgn]

What motor was it pulled from? Can you tell me if it runs true and if there is any damage? What is the pulley width?

 

[Randra]

PM sent

 

[khryslerkid]

This one is from a '63 413 Has the offset holes.

 

[paris401]

This one is from a '63 413 Has the offset holes.

View attachment 348888 View attachment 348889 View attachment 348890 View attachment 348891

these are off a 67 gtx

 

[ibsorgn]

these are off a 67 gtx

View attachment 348981 View attachment 348982 View attachment 348983 View attachment 348984 View attachment 348985

Thank you for the pics. I'm presently working with Randa but should things not work out I will be in touch. Very much appreciate your replying to my WTB.

 

[randys4406]

Thank you for the pics. I'm presently working with Randa but should things not work out I will be in touch. Very much appreciate your replying to my WTB.

If you still need one , I have two.