68-70 dash clock knob dimintions

[Dave1953]

I recently installed a NOS clock in my 1970 Dodge Coronet R/T but the knob was missing out of the box. I have a lathe and mill and can make one but I prefer to make it the correct size. Would someone out there be willing to measure theirs and let me know the size as well as if it is "knurled" or knot. If someone had an old one I would gladly make them a "new" one and send both of them back to them. Thank you in advance for your help. Dave easair@charter.net

 

[Lionized]

I've got an original clock in my Super Bee which I am replacing with the Tick Tock Tach. If they're the same reset knob, I would send you one.

Save you a little bit of trouble.

 

[bigmanjbmopar]

Not sure if this helps or not, this is on my 69 RR clock same knob as the rally dash. Best pics I could muster.

 

[Dave1953]

That would be awesome. I will be glad to reimburse you for all expenses. Drop me a line when you get ready to send it and I will give me your address. Dave easair@charter.net

- - - Updated - - -

Those pics are so good I could replicate it from them and the measurements alone. Is it made of aluminum or stainless?
Dave

 

[bigmanjbmopar]

Its chrome on plastic but you could do aluminum and polish it? center screw is steel which mounts to the clocks steel shaft

 

[Lionized]

Check your email.

 

[Photon440]

I have this one. It's chrome over brass.
http://www.performancecargraphics.com/Dash_Stuff/Hardware/B-body_Clock_Knob.htm