@66CoronetWgn
Member
Does anyone see a need for these? These are 3D printed versions of the plastic stand off / fastener used for the long screws that hold the inside trim to the body for the rear side glass. 12 are used in the 66 - 67 wagons, probably the same for 68-70. Not sure on newer years. An original part was scanned and modeled, then we printed these in several orientations - all worked well to re-attach my trim.
If interested, I could get more printed and sell a set of 12 for $60. To keep the cost fairly reasonable, they have to sell in full sets.
If interested, I could get more printed and sell a set of 12 for $60. To keep the cost fairly reasonable, they have to sell in full sets.