Buddy Seat Fitment

[streetmachine]

I have a question regarding fitment of a later Buddy (Jump) Seat out of a 1979 Chrysler Cordoba. I'm just wondering if this seat will fit or bolt into a 1971-1972 Dodge Charger with the type of setup? Thank you in advance.

 

[T2R9]

Did you get the brackets too? Those will weld to your floor pan, might need to trim adjust them a bit to fit but not much. Seat is the same as 71-74's

 

[streetmachine]

Did you get the brackets too? Those will weld to your floor pan, might need to trim adjust them a bit to fit but not much. Seat is the same as 71-74's

I can't remember if I have the brackets or not at the moment. That's good to know the seat is the same as the 71-74s so that means I will be able to keep it and use it. Thank you again.

 

[T2R9]

If you don't have them they are easily made out of some flat stock.

 

[streetmachine]

If you don't have them they are easily made out of some flat stock.

Thank you. I will keep that in mind. Need to start learning how to weld and fabricate eventually anyways.