ironside
Well-Known Member
Dana 60
A body width
4.10 gears and 35 spline spool.
Billet 1350 yoke.
Billet housing ends.
New 35 spline BBP axles, screw in studs, green bearings.
Calvert HD perches to your spec.
Everything new but housing.
Uses std 2.5 offset 11" drum or aftermarket disc brakes.
It is a truck housing. Not HD. 3" axle tubes, 0.250 wall. Tubes fully welded to center section.
Can install different gear at no cost. Can also install any carrier you like, but price would go up.
Comes urethane gloss black with epoxy primer base. Can leave in primer if you like or powder coating available too.
Never ran. Buyer pays shipping. But prefer pickup
as it is heavy.
Located SW MI.
1100 obo
Thanks FBBO
A body width
4.10 gears and 35 spline spool.
Billet 1350 yoke.
Billet housing ends.
New 35 spline BBP axles, screw in studs, green bearings.
Calvert HD perches to your spec.
Everything new but housing.
Uses std 2.5 offset 11" drum or aftermarket disc brakes.
It is a truck housing. Not HD. 3" axle tubes, 0.250 wall. Tubes fully welded to center section.
Can install different gear at no cost. Can also install any carrier you like, but price would go up.
Comes urethane gloss black with epoxy primer base. Can leave in primer if you like or powder coating available too.
Never ran. Buyer pays shipping. But prefer pickup
as it is heavy.
Located SW MI.
1100 obo
Thanks FBBO
Last edited:
