tdanz3
New Member
This motor was professionally built and installed in a 69 Coronet in 2006. I ran it for approximately 600-800 miles in 2006-2007 and replaced it with a 440 in the fall of 2007. It has since been stored in the machine shop's showroom. I have receipts and dyno sheets.
Specifics are as follows:
Magnaflux block
Bore cylinder
Hone cylinder
Comp cams # K21-306-4
New cam bearings
New oil pump model MEL-M63
New valves
Hardened valve seats
New springs/retainers
New rocker arms/push rods
New timing chain/cover
New distributor
New EDELBROCK Performer RPM manifold
Magnaflux heads
Pocket port heads
New expansion plugs
Grind/rebalance crank shaft
New KB400 pistons/rings/connecting rods
Moroso valve covers
Well over $4000 invested. . . asking $2495.
Specifics are as follows:
Magnaflux block
Bore cylinder
Hone cylinder
Comp cams # K21-306-4
New cam bearings
New oil pump model MEL-M63
New valves
Hardened valve seats
New springs/retainers
New rocker arms/push rods
New timing chain/cover
New distributor
New EDELBROCK Performer RPM manifold
Magnaflux heads
Pocket port heads
New expansion plugs
Grind/rebalance crank shaft
New KB400 pistons/rings/connecting rods
Moroso valve covers
Well over $4000 invested. . . asking $2495.
